It would depend on which mods you would like to do. For all mods you will need a screwdriver (open it up). A hammer and long screwdriver can be used to remove air restricters. If you have a power drill that makes everything a lot easier. Some Duct Tape can be used for plugging bad seals and Teflon tape can do the same.
mavric
same way you would mod any other Nerf gun
u cant simple
An integration mod is when you meld two Nerf guns into one amazing killing machine. The most common is taking the gun on the front of the Longshot and permanently adding it to the bottom of the main gun where the bipod is.
man, uh probably the vulcan but the end result was good but it took alot of time.
hubajiba
air restrictors
well... it depends on the type of gun if it was a maverik then you have to open it up and take off the air restrictors by drilling through it , on the other hand if it was a longshot then you would have to take the gun apart. In my opinion the bigger the gun the harder to mod
If you mean to mod it, check out this guidehttp://modworks.blogspot.com/2009/09/nerf-raider-mod-guide.html
There is no pump-action mod for a Nerf Raider CS-35; it already has a built-in pump-action mod due to the way it is fired.
the big bad bow or big blast. the titan takes to long to reload.
6 Nerf bullets unless mod
no really easy