A motor in a circuit is classed as the circuit's load.
A three phase motor control circuit.
Something wrong with it like a bad motor.
The terminology for a feeder is any wire that is coming into a device (it feeds the device with power). A feeder will be the wire coming into the disconnect and also the wires going into the motor will be called feeders. Even the wires coming into the MCC will be termed feeders. Branch circuits are circuits that usually originates at the main distribution and spread outward to their respective loads. Branch circuit terminology encompasses all of the equipment in the circuit that is connected from the overload device to the field load device.
It is proper "control sense" to fuse the control circuit. It does not have to be just a cartridge fuse, in many cases it is a breaker. Depending on where the control voltage is obtained from, transformer from the incoming motor feed, separate source, or line voltage, there is always a chance that a component of the control circuit could fail, circuit protection would lessen the damage to other equipment in the control circuit. The fuse should be sized as close to the control current as possible.
7.3 ohms
In the circuit where the DC motor is added, it was not specified whether the motor was added in series or in parallel to circuit elements. If it was added in series, it will increase circuit resistance and it will cause circuit current to go down. In parallel, the motor will reduce total circuit resistance, and circuit current will increase.
I HAVE A SMALL ELECTRIC CLOCK MOTOR THAT I NEED TO REVERSE. WHAT IS THE CIRCUIT I NEED TO REVERSE IT?
A three phase motor control circuit.
If the circuit was open, the tram's motor could not run!
A motor is not needed in a circuit, a motor is an electrical load for the current to drive, but the circuit can perform with other types of load - such as a lamp, a transformer, a heating coil, or any electronic load. if you mean 'why does an electric motor need a circuit?' this is because the motor is an electrical device which has coils of wire to produce a magnetic field, without the circuit it cannot function.
What supplies a dc motor is not current, but voltage. Current is what flows in the circuit formed by the dc motor and for the charge. That current varies according to the resistance of the circuit.
A circuit board is the inducer motor. It runs off of 120 volts.
The circuit breaker is sized to the full load amps of the motor times 250%.
The breaker should be sized to 250% of the motor's full load amperage.
By varying the Resistance to the motor. These Devices are called RHEOSTAT'S
Motor Protection Circuit Breakers.
it help start things in a circuit