To hold the nose ring watever
The cigarette power sleeve is held in place by a retaining ring at the top of the sleep. Turn the retaining ring to the left. Once the retaining ring is off the cigarette power sleep will come out.
There is a retaining ring that spins on and off. There is a retaining ring that spins on and off. There is a retaining ring that spins on and off.
The glovebox lock is held in place by two retaining screws, on the inside of the glovebox, and a retaining ring on the outside. Remove the retaining screws and retaining ring. Reverse the process to install the lock.
The lighted ignition ring is held on with to retaining clips. Pry outward on each retaining ring. The lighted ignition ring will come off.
The pressure a retaining ring can hold will depend on various factors such as the material, design, size, and application. It is important to consult the manufacturer's specifications and guidelines for the specific retaining ring you are using in order to determine its pressure capacity.
Turn it
you probably need a pair of snap ring pliers
many old cars are very similar, you need to remove the bezel screws first then loosen the three slotted screws on the retaining ring. turn the retaining ring a little to the end of the screw slot so you can remove it. Unplug the three prong plug and remove the light. ( if the retaining ring is old you may have to remove it if it will not turn)
for the halogen bulb from the inside turn the retaining ring counter clockwise and pull bulb out, install bulb in socket and reinstall into lamp, then turn retaining ring clockwise.
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
The cigarette lighter is held in place with a retaining ring at the top of it. Remove the retaining ring by turning it to the left. The cigarette lighter will come out. Reverse the process to install the new cigarette lighter.
It's in the fuel tank. Remove tank, use a chisel to undo to round retaining ring. remove module & replace. replace the rubber "O" ring and retaining ring. Reverse to install, don't forget to chage the fuel filter also.