It doesn't exist. NO, it does not exist. I don't care what that idiot told you, it doesn't! Now, a spark plug WIRE goes from the distributor cap or coil pack to the spark plug. (cables have multiple conductors, wires are singular, JSYGK.
Sparks plugs are replaced by disconnecting the battery, removing the spark plug cable and boot, and by removing the old spark plug. Next put in the new spark plug, attach the boot and cable and reconnect the battery.
Spark plug diagram for '98 buck regal
hoe do you put then spark plug cable in the right order on a impala
Remove the chrome cover, pull out the plug cable, use the spark plug socket with a ratchet.
Disconnect the battery, remove the spark plug covers and cable, and remove the old spark plugs. Put in the new spark plugs, replace the covers and cable, and reconnect the battery.
don't have, its just the cap on top of the engine
Take the seat off , then the right side cover . The spark plug will be behind the ground cable on top of the motor . Should be a special spark plug tool in your tool kit .
The factory service manual says that to get the spark plug wire off of the spark plug: Twist the boot about a half turn to loosen it from the spark plug and then pull it off using the boot. Don't pull the spark plug wire to remove it as you may find yourself pulling the wire out of the connector. Pulling it off by the boot may also leave the connector on the spark plug.
To change the spark plugs on a Vauxhall Zafira open the hood of the vehicle. The spark plugs will be located on the engine. It is best to used a spark plug removed to unscrew the plugs. They will be connected to a cable. Remove the cable. Replace the plugs with new ones and reattach the cable.
Check the spark plug cables and spark plugs themselves. I had the same problem about 3 months ago, and it was a bad plug cable and a bad plug as well.
Removing spark plug wires is rather easy. All a person needs to do is grab the top and the bottom of the cable wires firmly and pull.
1. Remove the engine cover.2. Disconnect the VIS actuator connectors and injector connectors.3. Remove the accelerator cable.4. Remove surge tank sub assembly. 5. Remove the spark plug cable.6. Remove the spark plug.7. Install Iridium only plugs.