0
molding applied externally to paneling or walls
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How does blow moulding work?
hello
Will a door from a 1994 z24 fit a 2000 z24?
No only 1995-2004 will work Pontiac sunfire doors from 95-04 will work also but the door moulding and door panel will need to be changed
How do you remove the rear interior side panel of a Toyota Previa 05?
Remove 2 plastic covers and 2 seat anchor bolts (14mm), then remove the seat half; Remove seat belt rubber cover and bolt (14mm); Slightly pull out the rear hatch rubber moulding to release 3 thin metal tab at the rear end of the panel from the moulding; Slightly pull out the side door rubber moulding to release a tape which hold the front end of the panel at the top; There are 2 plastic fastening pieces at the lower front of the panel that need to be pulled off. Now the panel can be pulled out at the bottom first, then pull up and out at the top to clear a series of metal hooks at the top of the panel. Installed in reverse order. dtn.
What is rotational moulding?
its a type of moulding :)
What is a bed moulding?
A bed moulding is a moulding in architecture of a cornice immediately below the cornea.
What is short moulding?
The resulting moulding with incomplete filling of the plastic resin is called in practice as short moulding.
What is moulding in agriculture?
moulding in agriculture is where scrapped in heaped up around a small surface of a plant
What are 3 benefit of moulding?
What is 3 benefit for moulding
How tall is Joshua Moulding?
Joshua Moulding is 6'.
How tall is Steven Moulding?
Steven Moulding is 6' 3".
How can plastic moulding be fitted?
There are many different types of plastic moulding, most of which is manufactured in China. Depending upon which type of plastic moulding is used would determine the way the moulding is fitted.
How do you remove trim moulding from a buick regal?
Answer Trim moulding is easily removed with a heat gun. A good hair dryer might work, but a heat gun is much hotter and gets the job done faster.
