How do you remove the rear interior side panel of a Toyota Previa 05?
Remove 2 plastic covers and 2 seat anchor bolts (14mm), then remove the seat half; Remove seat belt rubber cover and bolt (14mm); Slightly pull out the rear hatch rubber moulding to release 3 thin metal tab at the rear end of the panel from the moulding; Slightly pull out the side door rubber moulding to release a tape which hold the front end of the panel at the top; There are 2 plastic fastening pieces at the lower front of the panel that need to be pulled off. Now the panel can be pulled out at the bottom first, then pull up and out at the top to clear a series of metal hooks at the top of the panel. Installed in reverse order. dtn.
When replacing an interior door handle on a Toyota Camry do you have to take off the entire door panel?
You are not required, but you have to. There is a transparent plastic protection behind the panel. If you do not remove the panel if have make holes in order to remove the handle. To do it more professionally, remove the panel, carefully remove the protection cover (it's attached with sticky viscous black colored glue.) After that you get access to the handle.
is under the passenger seat, remove the pass seat, and base, lift up the carpet remove floor panel and you will see the wiring harness for the plugs, and the plug locattion. under the pass, seat remove the seat and base lift up the carpet, remove the floor panel and you will see the harness and the plugs..