0
the quad driver is basicly half of the pcm or computer in the car . it will either be resposible for the input or output side of the computer or 4 of 8 0r quad portion of your computer . also if you disconnected a sensor or your lockup connector at your transmission you can induce this problem.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How can you tell if the quad drivers are bad in a 1991 Oldsmobile Cutlass Ciera S?
Need to know what quad drivers are...
Where is quad driver located at on Oldsmobile Cutlass Calais S 2.3?
In the computer.
Where is the Quad driver module on a 1994 Oldsmobile cutlas cieara s?
It is really non fo your consern
I got a 1991 Oldsmobile Calais with a quad 4 and 5 speed manual transmission is it possible to take a 1986 Buick century 3800 and mount it to the 1991 quad 4 manual transmission?
Will not bolt up and is not strong enough for the 3800.
When did Quad Challenge happen?
Quad Challenge happened in 1991.
What motors interchange with 1988 Oldsmobile calais 2.3?
The Oldsmobile Calais, also known as the Cutlass Calais, was produced by General Motors from 1985 to 1991. In 1987, the Quad 4 engine was developed and the 1988 Calais was fitted with it. All?æof the Quad 4 14 engine types of the 2.3 liter version are interchangeable on the 1988 Calais.
Where is the Qaud Driver module located on a 1991 Buick Century Custom?
Quad drivers are small chips that perform on off functions inside the Engine Control Module. If you have a code which states there is a Quad Drivers Error, you need to check the items that that particular Quad Driver is controlling. For example, the a/c compressor relay, or trans solenoids etc...
When was Quad Challenge created?
Quad Challenge was created on 1991-08-06.
How can i fix the quad driver module on a buick park avenue 1993?
the quad driver module is a component of the ECM. you must replace ECM.
1994 Pontiac transport has a quad driver module failure how can this be corrected?
Look at your error codes again. It should read something like "quad driver module FAULT" not failure. It is VERY unlikely that your quad driver actually died. It is the high power control system that is in your computer. So replacing it, means replace the computer. To prevent this the Quad Driver has all sorts of internal protection hardware in its design. The likely thing that is wrong is something the Quad Driver is connected to. And that The quad driver isn't seeing every thing correctly so thus the Fault. It also can fault if there is a wiring problem from the device to the quad driver. There are Test for each component. You should to to find out which is the problem. Consult your Shop Manual.
Where is the quad driver module on a 1989 Buick 3800?
If a quad driver has gone bad it is necessary to replace the ECM. After replacing the ECM, drive the car on a bumpy road and note whether the check engine light comes on. If it does, fix the problem or you end up with a repeat QDM failure. == == == == There is no such thing as a quad driver module. There are quad DRIVERS in the ecm.
Where is the ECM and quad driver modules on a 1991 3 3L Buick century?
Relays are right behind the left side headlights - under the hood. I am looking for answer on nthe ECM myself...
