0
What is a typical vacuum pressure on an idling 4 stroke engine so I can sync a carb set on a Yamaha outboard and make sure I don't suck the manometor fluid into the cylinder?
Wiki User
∙ 16y ago
I found a really good site that helped me a lot. http://www.centuryperformance.com/vacuum.asp
Hope this helps!!
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the typical change in blood pressure with increased intracranial pressure?
inreasing pressure
What is the oil to gas ratio for a 2 stroke 150 horsepower Johnson outboard motor?
50:1 oil mix is typical for outboard two-cycles. Some do a little more in the winter.
What are some of the typical forms of peer pressure?
Drug peer pressure, peer pressure related with alcohol, sexual peer pressure, and even peer pressure to break the law, are some of the most typical ones.
Does the slave cylinder open and close?
No, the slave cylinder is a typical hydraulic piston; if the system was 'opened' then the fluid would come out.
What component reduces the main pressure for a typical gas furnace?
Negative pressure switch
How much faster will a 200 HP outboard go vs a 150 HP outboard on a typical bass boat?
Depends on the boat. Aluminum boat, 65-73. Fiberglass, 60-65.
What is the typical air pressure in oshawa ON CAN?
Air pressure, everywhere, varies day to day dependant on weather factors
Why does the pressure under a train need to be low?
On the typical train, there is no effort to control pressure above or below a train.
What is the typical Reid vapor pressure range in naphtha?
15 psi
What is the maximum reading on a typical r410a high pressure gauge?
800psig.
What is the typical pressure at which an oil burner operates?
100-140 psig
How do differential hydraulic cylinders work?
A differential cylinder has a large piston that requires a greater amount of oil to displace the cylinder, thus allowing greater uniformity of force than a typical single-acting cylinder.
