0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the price for a front wheel bearing for a 2000 Pontiac sunfire?
Well its a wheel bearing hub assembly that you need to buy. Autozone has a Timken/Wheel Bearning/Hub Assembly-front its $79.99 and they have the Duralast/Wheel Bearing/Hub Assembly-Front $51.99
How do you tell if you have a short or long wheel base Van on a 2001 Pontiac Montana?
Measure from the center hub of the front wheel to the center hub of the rear wheel.
How do you replace the rear wheel bearing on a 2003 Pontiac Montana?
The bearings are not replaceable, they are a part of the rear hub assembly - the studs and the bearings are pressed in - replace the whole hub assembly - 4 bolts are holding it. Rear bearing/hub bolts (new only) are to to be torqued to spec. [2000 Montana - 85 Nm (63 lb ft)]
How do you change the wheel bearing hub assembly on a 97 Pontiac Grand AM?
Fron or rear?
How do you remove a stuck-on wheel hub from a 1998 Pontiac Grand Prix?
http://www.paulstravelpictures.com/GM-Wheel-Bearing-Hub-Assembly-Replacement/index.html
How do you remove front wheel hub assembly on Pontiac vibe?
The frontdoes not havea "wheel hub assembly". It is an individual sealed roller bearing that has to be pressed on and off the front spindle. It is a Toyota thing!
How do you change a rear wheel bearing on a 2000 Pontiac Montana?
You need to replace the rear wheel hub - bearing and speed sensor inclusive
How do you Replace front wheel studs on 2000 Montana?
You replace the wheel bearing hub assembly - it has studs, bearings and wheel speed sensor around $100 part
How do you replace a wheel bearing on a Pontiac Montana?
Wheel bearing is part of an hub assembly. Remove wheel, remove caliper & rotor. Disconnect speed sensor, unclip connector. Remove shaft nut in front & 3 bolts in back - replace with new hub/bearing/studs/wheel speed sensor assembly tighten to spec. You need to also remove the big shaft nut. When replacing make sure axle nut (33mm) is torqued to spec. [160Nm (118lb ft); hub bolts (13mm) torque spec: 130Nm (96lb ft) - 2000 Montana]
How do you replace front hub assembly on a 1998 Pontiac transport?
remove wheel, caliper,brakes,rotor. unplug abs connector and unbolt hub. install is reverse.
How do you replace a wheel assembly on a 2000 Montana with out cutting the abs wires?
You need to remove the hub assembly and replace it. It consists of bearing, studs and speed sensor. The wires are attached to a connector which is clipped to sensor shield. You cannot remove sensor on Montana without removing the hub. The sensor is a part of assembly.
Does a wheel bearing come with the wheel hub assembly?
With a Wheel Bearing Hub Assembly, you might get both the wheel bearing and the hub assembly. Sometimes, especially with FWD vehicles, the front hubs will not have the bearing with them but the rear hub assembly will. Most part manufacturers will follow what ever the auto company recommends.
