0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are symptoms of excessive piston to bore clearance?
excessive piston to bore clearance means that the gap (tollerance) between your piston and the sidewall of your cylinder/block is too large. usually will cause blow-by. the burning of oil, and dark exhaust smoke. also may cause the engine to have a weak compression stroke
What is normally used to maintain the correct piston-to-cylinder clearance?
The clearance between the piston and cylinder is maintained by the piston rings, the ring centers the piston within the cylinder bore and is the device that seals the cylinder bore and creates and maintains the pressure created by the piston movement in the bore. When assembling an engine you will need to check and set end gap of the rings, this is done by centering the new ring in the bore and measuring the gap between the ring ends, you can measure this distance with feeler gauges and adjust by filing the ends of the rings to increase to the recommended tolerance, this tolerance is measured in .000 of an inch and different engines require different end gaps. This end gap is determined by the diameter of the bore with the greater the bore diameter than the greater the end gap,.
What is bore and stroke in a motorbike?
Bore is the diameter of the piston/cylinder, stroke is the distance the piston can travel between its highest position and its lowest position in the cylinder.
Cylinder bore formula?
this is the diameter of the cylinder hole in the engine block for the piston
1992 trx 250x a valve broke off damage to the head and piston did not hurt the cylinder can you just get it honed or does it need bored out?
If there was no damage to the cylinder bore then you will not need to bore it oversize.If there was no damage to the cylinder bore then you will not need to bore it oversize.
What is an aircraft piston engine cylinder bore?
The bore refers to the Inside diameter of the cylinder. The Piston will be nearly the same diameter, with the piston rings making up the difference. Convert the bore to area by multiplying by pi and dividing by four, and multiply by the stroke and the number of cylinders and you have the volume displacement of the engine.
What is a piston slap?
piston slap is when the piston inside the cylinder is somewhat smaller than the cylinder bore. when the piston moves up and down, it ends up moving side to side too. this causes a knocking/slapping sound as the piston slams into the cylinder walls.this can cause harm if the play between the piston and bore are significant, otherwise it's nothing to worry about. if the car is hammering you might want to take it to a garage.Piston slap is the piston lose is the cylinder and it is making a rattling noise.Hope this helps.
The bore of the cylinder of a piston engine is normally ground with a slight choke?
Generally the nominal diameter of cylinder bore is kept little smaller at cylinder head than at the bottom. The engine head will be generally heat and it tends to expand for these high temperatures. To prevent the bore diameter at head to exceed diameter at bottom,piston engine bore is ground with a slight choke.
The piston displacement of a specific engines is meaning?
The piston cylinder bore, times the cylinder stroke, times the number of cylinders gives you the specific displacement for a particular engine.
What is the engineering piston bore size for a 1966 mustang 200 ci 6 cylinder?
3.68 bore x 3.126 stroke
What is the piston displacement of a master cylinder with a 1.5 inch diameter bore and a piston stroke of 4 inches?
9.4247 cubic inches
How is the piston to bore clearance measured in an engine that is being rebuilt?
There are several ways.You can:Use a long feeler gauge and see if the piston has clearance in excess of the size, usually you use several in succession to determine clearance to + or - .001 inch or .01 MMUse a Micrometer and bore gauge that have been properly calibrated.There are other ways but those are the most common.
