REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
Yes
Ignition coil is bad, is it right on top of the cap maybe a bad wire in the wirng harness or bad connector.
It depends on the engine. If it is a 3.3 v6, you will locate it under the 3 ignition coils. Unbolt each coil, 2 screws per coil, and the unit will be free, other than the primary wiring harness. The primary wiring harness is connected by a bolt, through the connector and into the module.
The ignition only needs 12 volts for starting. You`re wiring harness has a resistance wire or ballast resistor to drop the voltage to keep the ignition coil from burning up.
The ignition coil is inside the ignition distributor.
No. The coil provides the spark and the module tells the coil when to spark.
the ignition module is in front of the lft front wheel,inside the fender. the module wiring harness runs thrue a hole /gromet in the fender into the engine compartment just in front of te ignition coil.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
1999 Alero how do i test ignition coil pack
The ignition coil that is suitable for the hall sensor ignition must have a yellow label.