the right way to do it is apply blockfiller first, blockfiller is a thick acrilyc water based paint that can be applied by roller and brush. it fills all the cavity's so you can obtain a uniform appearance with the finish coat(s). then you just need to decide between flat,eggshell or semi-gloss finish.(assuming it`s an interior wall) flat hides defects best but is not washable. that can be bad if you have small children! eggshell has a little shine to it but is washable. (i`m a commercial painter and this is what we usually use in office`s school`s etc. where there`s high traffic.) semi-gloss has the highest sheen and is washable but usually reserved for trim (doors, frame`s base etc.) as most people don`t like glaring walls. for an exterior wall blockfill then you have the same choice`s to make just with exterior paint.all blockfiller is good for int. or ext.
You should use a special concrete and masonry paint and primer. -Available in Rona and Home Depot.
sand , cement ,lime,aluminum powder 0.05% mixed
The best type of glue for ABS is Oatey Standard Yellow cement.
1:5 (cement:sand) is the best ratio
Water based paint with a satin finish. This paint type looks the best on interior walls, in my opinion. The water based paint makes for easy clean up as well.
plywood
Only oil and acrylics are the best type of paint to use on a canvas. Any others will not work right.
It is a type of glue used for gluing pipes together... (not the type of cement in concrete).
a sturdy one probably made of cement
type of cement using in cambodia
sharpie is the best type of permanent marker.
For the ceiling that your looking for would be cement
Watercolor paint, similar to the type you may have used in kindergarten.