HOW IS BEST WAY TO REMOVE BULB ON THE GMC CANYON FOR LICENSE PLATE LAMP ?
Remove 1. Bolts retaining license plate lamp to bumper. 2. Socket from license plate lamp. 3. License plate lamp. 4. Bulb from socket. Install or Connect 1. New bulb to socket. 2. Socket to license plate lamp. 3. License plate lamp. 4. Bolts to retain license plate lamp to bumper.
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
Remove two rear lamp bolt/screws from rear license lamp. Remove lacense lamp from rear bumper fascia. Remove license lamp bulb and socket from rear license lamp. Replace bulb and install using reverse procedure.
How do you change the lamp on the license plate of a lincoln ls 2000?
Open the trunk, then remove the 1st and 2nd rows of black liner insert pegs. The color of the pegs may vary. Lower the trunk liner enouph to see the inside of the license plate lamp. Remove old lamp and install the new one. The job takes about 15 mins.
Replacing license plate lamp bulbsThe license plate bulbs are locatedbehind the rear bumper. To changethe license plate lamp bulbs:1. Reach behind the rear bumper tolocate the bulb.2. Twist the bulb socketcounterclockwise and carefully pullto remove it from the lampassembly.3. Pull out the old bulb from thesocket and push in the new bulb.4. Install the bulb socket in lamp assembly by turning it clockwise.
# Remove the license plate. ## Remove the screws from the license plate lamp. # Remove the license plate lamp from the end gate. # Remove the license plate lamp socket, turning counterclockwise. # Remove the bulb from the license plate lamp socket. ## Install the bulb to the license plate lamp socket. # Install the license plate lamp socket, turning clockwise. Notice:Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.# Install the license plate lamp to the end gate. TightenTighten the screws to the license plate lamp to 2 N·m (18 lb in). # Install the screws to the license plate lamp. # Install the license plate.
there should be little screws that you screw out and they pop out and you twist the bulb to remove it
To change the license plate lamp on a 1998 Bravada, locate the bulb. Visit an auto parts store to obtain the exact bulb and screw it in place.
I think for most cars, the license plate lamp is on the same fuse as the taillights, so if the taillights are working, and the license plate lamp isn't, check the globe or the wire
how to change 2005 equinox license plate light i removed the screws but it didn't release
part 168