0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is function of breather and explosion vent of 3 phase transformer?
breather to observed moisture from the tank and explosion vent will works when the moisture will get observed in the tank then it will explodes from the explosion vent by breaking diaphgramAnswerThe breather allows air to enter and leave the transformer's sealed tank as the transformer oil contracts or expands. The breather is fitted with a silicon-gel chamber to ensure that any air entering the tank is dry. A viewing portal allows the viewer to determine whether the silicon gel crystals are still active.The explosion vent is a large-diameter tube, usually located at the top of the transformer tank, sealed with a frangible plate or diaphragm. Should an explosion occur within the transformer due, for example, to a catastrophic short-circuit fault, then the blast of the explosion will be allowed to escape through the explosion vent, rather than causing the transformer's tank to explode.
What is a wet vent?
Definition: Wet vent means a waste pipe that also serves as a vent pipe
Is there a high wind vent cap for a gas furnace roof vent?
Yes you can get a high wind cap for the vent.
What plumbing devise replaces a vent pipe?
A auto vent
Where does the crankshaft breather hose connect on a gy6 motor?
to the air box
What is a breather used for?
Allow pressurized gases to vent from the crankcase.
Dose the breather vent have to be hooked up on a 350 turbo trans?
breather vent on top of tyranny is open to air the only vacuum hose that's hooked up is shift modulator to constant vacuum on manifold
Can you route breather tube into oil tank with a vent on top to atmosphere?
Not enough info.
Is breather a noun?
Yes, the the word 'breather' is a noun, a singular common noun.The noun 'breather' is an abstract noun as a word for a pause or a rest.The noun 'breather' is a concrete noun as a word for one who breathes; a vent or valve to release pressure or to allow air to flow.
Where is Fuel Tank Vent Valve on kia sorento 2003?
The 'vent valve' is a breather... it has no moving parts... they're typically placed at the top of the fuel tank.
Where is the breather vent on a th350 transmission?
It is on the drivers side, near the top, a little bit forward of the linkage.
Where is the transmission breather vent?
On an A/T it is the check/fill dipstick. On a manual, it is located on the top of the trans.
What is function of breather and explosion vent of 3 phase transformer?
breather to observed moisture from the tank and explosion vent will works when the moisture will get observed in the tank then it will explodes from the explosion vent by breaking diaphgramAnswerThe breather allows air to enter and leave the transformer's sealed tank as the transformer oil contracts or expands. The breather is fitted with a silicon-gel chamber to ensure that any air entering the tank is dry. A viewing portal allows the viewer to determine whether the silicon gel crystals are still active.The explosion vent is a large-diameter tube, usually located at the top of the transformer tank, sealed with a frangible plate or diaphragm. Should an explosion occur within the transformer due, for example, to a catastrophic short-circuit fault, then the blast of the explosion will be allowed to escape through the explosion vent, rather than causing the transformer's tank to explode.
Why is Water is being sucked up the air pipe on the bathtub plumbing?
Please re post your question. What air pipe,are you talking about the breather vent inside the wall. If you are talking about the breather vent,it is not getting sucked up it is from water being backed up in your drain,and the water can not drain quickly enough, the drain needs to be cleaned.
There is a vent hose from the engine that runs underneath the truck on top of the transmission on my 2002 Chevy Avalanche can you tell me what this is It has some oil residue in that area?
The vent hose is for either the transfer case breather or the transmission breather. A light amount of oil residue is normal. If there is a lot of fluid coming out of the hose then it is most likely caused from the transmission getting too hot.
Where is the air vent on a 1995 jeep ax-5 transmission?
The breather vent for the AX5 is located on the top front of the shift tower. Remove the rubber shift lever boot to expose the vent from above. It appears as a small metal cap about 3/4"tall and should spin freely.
Why would transmission fluid be leaking from the breather tube?
Assuming you mean transmission vent: 1) Excessively high fluid level. 2) Tube has hose incorrectly located.
