In general, it's everything that starts at the meter base and goes to the lights or electrical outlets. House wiring is typically behind walls, under floors or in the attic so it's the wiring that you don't typically see, but use it every day.
This usually refers to the building's electrical wiring.
Inside your walls, copper conductors have been installed to deliver electricity throughout.
Copper holds a 92-percent market share of electrical wiring in building (8 percent aluminum).
Surface wiring in an existing building when there is no other way to get the power to the place that you want it.
You do not say if you are wiring AC or working with Dc 12 volt wiring.
Old wiring refers to electrical wiring systems that were commonly used many decades ago. This includes aluminum wiring, knob-and-tube wiring, and cloth-covered wiring. These types of wiring may not meet current electrical safety standards and can pose a higher risk of electrical problems or safety hazards in homes and buildings.
US NEC: You must provide a box to join the old and new wiring together. Also, when making modifications to old wiring, you must upgrade the old wiring as needed to meet current code.
the building wiring installation and symbols book.
Electrical wiring standards are defined by your local municipal building Inspector. Wiring standards will vary depending on your local ordinances. Just contact your local building inspector for the requirements in your area.
Copper holds a 92-percent market share of electrical wiring in building (8 percent aluminum).
use wiring tool it is number 4 or 5
Red or Blue
Find a copy of the buildings blue prints and turn to the E section of the prints. There the whole electrical layout of the building can be found.
Surface wiring in an existing building when there is no other way to get the power to the place that you want it.
These types of vehicles will have their own regulations as to their wiring, as governed by the manufacturer of the equipment. The building that the vehicles are stored in will be under the electrical code mandate.
because earth doesn't catch fire or electricity
Buildings that do not conform to building regulations may not be structurally sound and may collapse, killing their occupants. Various aspects of construction, such as wiring, adequate availability of exits in case of fire, etc., can affect the safety of the building.
It depends on whether the building classification is combustible or non combustible. On a new commercial building wiring is usually designed by an electrical engineer. In this case the wiring is done to their specifications. On a rewire of a commercial building BX cable can be used behind wall board. The reasoning is that most commercial buildings these days use steel studs. Dragging ordinary NMD wire through these types of studs can cut the outer sheath. In some jurisdictions steel stud bushings have to be used when a steel stud is hole punched. By using this type of wiring cable, rigid conduit or EMT does not have to be used.
If it is a Harley, wiring diagrams are located in the manual for that particular model