First I suggest leave the door open and hold the door button down on the left hand side at the bottom of door manually and start the truck.If the interior light is still on when this happens you need to tighten the 2 screws that hold it and recheck.Now if this did not work with the truck running and the buzzer is still on try lightly moving the ignition switch back and forth (very lightly) and if it stops it means you need to replace the ignition switch itself due to age and wear.In short what can happen is the contacts on the key ignition wear down making poor contact causing this and this can occur when you turn the truck off and the door buzzer continues until you move the key a little or shut the door which pushes the door (interior light switch to go off when the interior light switches are set to door). Check the two items I would bet it is the key switch is worn and not the door switch which the door itself pushes in to cut off the interior lights with the door closed.The set belt has NOTHING to with this.
hello my name is my
That is the correct spelling of "plugged" (closed a leak, drain, or opening).
Could be that the sensor in the door isn't registering that the door is closed.
yes, it happened to me, what it was, the solenoid of the starter motor got stucked at the closed position causing it to continue working even doe the ingnition key was removed. yes, it happened to me, what it was, the solenoid of the starter motor got stucked at the closed position causing it to continue working even doe the ingnition key was removed.
Low on coolant (leak in the system), Stuck closed thermostat, Faulty fan clutch, plugged up radiator (inside and/or outside), Bad head gasket,
Water pump malfunctioning. Thermostat stuck closed or partially closed. Radiator plugged with sediement.
Windows should be closed during strong winds to prevent them from entering the house and causing damage.
to ensure the system will continue to be sustained after production lines have closed.
Check for: -bad alternator -wiring harness to alternator burned -glove box warped causing light to stay on -door not fully closed causing light to stay on -burned headlamp switch -radio improperly installed -bad battery -cell phone charger or radar detector plugged in -electrical drain not related to one of the above
Where can I find a fuse diagram for a 1997 dodge 3500 diesel truck? The door buzzer module is sounding with the driver's door closed and the truck moving.
yes. if the valve is plugged or stuck closed, oil can be sucked into the intake through the pcv breather.
to ensure the system will continue to be sustained after production lines have closed.