0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the command that test connectivity by sending an echo request to a remote computer?
Ping
What is the ping command to send 9 packets as a test?
For a Microsoft Windows computer: ping -n 9 For a Linux computer: ping -c 9
What command would you use to send packets to another computer?
Ping
Command used to test the connection to other computer in the network?
I believe the command you are looking for is "Ping".For example, if your computer has an IP address of 192.168.0.2, and the other computer has an IP address of 192.168.0.3, then you would typeping 192.168.0.3... from the .2 computer. You should see response times.The etymology is from ping-pong. You send a ping from one computer to another, it sends a pong back.
What do you type using the ping command to find the name of a computer on a local network?
The ping command won't tell you the name of a computer on a LAN by using the network address. Using other commands such as nslookup may help with that.
What is the Difference between Ping and latency?
As a metric of network performance, Ping, also known as Network Latency, is a measurement of the time that it take for a small message (or a "Ping") to be sent from your computer to another computer on the internet, then returned back to you. Ping is typically measured in milliseconds. Low numeric results or a "Low Ping" is desirable for good network performance over a "High Ping". Ping is also the name of of command-line command that can be typed to initiate a "ping" and measure the time that it takes for the message be returned to your computer.
Which command is equivalent to the command PING Localhost?
ping 127.0.0.1
Which networking command is most popularly used to test the connectivity of between systems and networks?
The ping command. Traceroute is also useful, but I would start by using the ping command.The ping command. Traceroute is also useful, but I would start by using the ping command.The ping command. Traceroute is also useful, but I would start by using the ping command.The ping command. Traceroute is also useful, but I would start by using the ping command.
What command is used to determine if another computer is reachable via tcp ip?
Ping or tracert.
What is purpose of command ping?
ping is a test command. It sends a "ping" to a specified IP which should ACK back, when the ACK is received the message turnaround time is calculated. If the IP fails to respond it times out and reports failure. You can use this command to verify network connectivity, etc.
What command verifies the existence of a node on a network?
PING command verifies the existence of a node on a network. Ping command is a command of command line interface . It is used to check if the host is alive or not.
How can you find out ip address using computer name?
Answer:Most operating systems support the NSLOOKUP command. Use the following example to perform the address-to-name translation:nslookup 127.0.0.1If the system is properly registered in the global Domain Name System (DNS), a name will be provided in response to your query.AnswerIn addition to the above, the "host" command is also now supported on most Linux distrubutions. In fact, on most Linux distros the 'nslookup' command is considered to be deprecated.host 192.168.2.5
