0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What type of transformer connection can be used when it is necessary to rectify alternating current into direct current with a minimum of ripple?
bride transformer
Why is the Neutral fundamental in a three phase Y-Y Transformer connection?
Suppression of harmonics
The Most suitable and economically connection for small high voltage transformer is?
delta star
What is the difference between an ordinary transformer and a center-tapped transformer?
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
What electrical phase does H1 denote?
H1 is a terminal designation on the primary side of a transformer. The counter part to this terminal is H2. These two terminals are the connection points for the primary coil of the transformer.
What is The Connection in three phase transformer?
the connection here meant for the connection of windings in three core or limbs of a transformer. it might be delta or star connected.
Do I need tertiary winding in a auto transformer with vector YNynO?
Depends, do you need to connect auxiliaries/generator/capacitor/reactor to tertiary? If not you may consider to not to use tertiary. The 3rd harmonic current will become an issue then. The phase to ground Isc will be lower.
Want to know about transformer connection?
primary or secondary
What type of transformer connection can be used when it is necessary to rectify alternating current into direct current with a minimum of ripple?
bride transformer
What is the principal use in star - delta transformer connection?
i thinkecause he like sit idkk
The Most suitable and economically connection for small high voltage transformer is?
delta star
Why is the Neutral fundamental in a three phase Y-Y Transformer connection?
Suppression of harmonics
What is the difference between an ordinary transformer and a center-tapped transformer?
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
What is centre tap transformer?
In electronics, a center tap is a connection made to a point half way along a winding of a transformer or inductor, or along the element of a resistor or a potentiometer. ..
What color should a H2 Conductor on 480 volt transformer should be marked?
The conductor for H2 connection on a 480 volt wire transformer should be marked:
What type of connection is used in power grid connection between generation and distribution?
A step up transformer is used at this junction in the electrical transmission system.
What is the difference between the center tapped transformer and ordinary transformer?
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
