GFI is a mini circuit breaker that responds to shorts or contact with water
the circuit breaker spark when it comes an over load, loss contact,but the probable cause is loss contact...and also the circuit breaker is going to be damage or destroyed.
Arcing is caused by a poor electrical connection. The breaker is not making good contact with the buss bar. Try replacing the breaker.
The neutral is in contact with the ground at some point of the circuit.
To the best of my knowledge, DTE dose not install breaker boxes. To have one installed you should contact an electrician.
Contact Breaker Gap must be: 0.020 in (0.05mm) Dwell Angle 35 to 37 DEG (up to engine No:1639762) HOPE THIS WILL HELP.
0.12-0.15
0.5mm
Breaker Gap, Inch: .015
You need to be more specific. Do you want a contact telling you if a circuit breaker is on? If that is your question, the answer depends on the model of the breaker.
0.025
GFI is a mini circuit breaker that responds to shorts or contact with water
According to the Ford shop manual, the breaker point gap, for the 3 cylinder , should be set at 0.024-0.26. Firing order is 1,2,3. AG5 Autolite plugs recommended with gap set to 0.023-0.027.
the circuit breaker spark when it comes an over load, loss contact,but the probable cause is loss contact...and also the circuit breaker is going to be damage or destroyed.
set at .017. remove distributor cap, turn crankshaft until the heel of the breaker arm is on the highest point of the cam, now check the gap. If it needs adjustment insert a screwdriver in the notched hole in the contact breaker plate and hold it still while you loosen the retaining screws, turn clockwise to increase, counter clockwise to reduce size of gap,check with correct feeler gage, then tighten screws.
Contact breaker point gap 0.45-0.55 mm Distributor dwell angle .49-55 deg Ignition timing at idle speed 7 deg btdc in neutral That's the same for A14 & A15
In a vacuum breaker the moving contact and fixed contact are sealed inside a vacuum chamber. Electrons cannot flow in a vacuum, therefore as soon as the moving contact seperates from the fixed contact the arc meets an infinite resistance and is immediately extinguished. Because of this, the gap between the fixed and moving contacts when the breaker is open need only be a tiny amount.