answersLogoWhite

0

What is detection antenna housing?

User Avatar

Anonymous

11y ago
Updated: 8/20/2019

Harem

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What is detection antenna housing called?

The housing used for a detection antenna is called a radome. This type of housing is made from transparent material, which is often found on the outer surface of an aircraft.


Chevy Caprice power antenna replace?

In my 89 you need to remove the wheel and the inside wheel housing, to get full access to the antenna.


How do you change the antenna base on a Ford Focus?

how can i change the antenna base on ford focus its broken Remove the maplight cover and bulb housing. There is a single screw that secures the antenna base.


How do you replace an electric antenna on a 89 caprice classic?

In my 89 you need to remove the wheel and the inside wheel housing, to get full access to the antenna.


How do you replace power antenna on 1992 corvette?

Remove left rear wheel plastic housing cover under the body you can then access the antenna motor.


How do you replace the antenna on a Ford Focus?

To replace the antenna on a Ford Focus remove the antenna from the base using a screwdriver. Remove the lighting assembly hose with a small key. Remove the plug in wires and the plastic housing. Put the new antenna base in place than screw in the new antenna.


Where is the antenna on a 1999 Honda Civic?

The antenna on a 99 civic is normally located on the roof next to the drivers side door on the roof. There should be a black casing right above the windshield and the antenna should be right there, if there is a casing and no antenna then someone has pulled it out and you will have to replace the entire antenna housing. Hope this helps.


How do you replace automatic antenna on a 1990 Toyota Celica?

First, you must go into the trunk of the car and remove the left side panel beside the antenna. this chould expose the antenna motor and electrical housing. Disconnect the 2 plugs and remove the antenna. Instalation is the same but in reverse ;) <3


How do you replace the electric antenna mast on a 1990 Honda Accord EX?

Remove the nut, spacer and bushing that holds down the antenna on the outside car body. Then turn the radio ON. As the antenna extends out, carefully pull out the antenna mast. There will be a plastic portion with teeth at the end. Remember the direction of teeth. When you install the new antenna, the teeth will go in that direction. Insert the new antenna into the antenna housing. Make sure the antenna teeth engages the antenna motor by moving the antenna up & down. Turn the radio OFF and the antenna motor will pull the antenna back in. Reinstall the nut, spacer, bushing and you're done.


How do you remove the antenna on a 1984 Jaguar XJ6?

To remove the antenna on a 1984 Jaguar XJ6, first, ensure the car is turned off and the battery is disconnected for safety. Access the antenna by removing the interior trim panel if necessary, and locate the antenna's mounting nut or bolt. Unscrew this fastener, then carefully pull the antenna assembly out from its housing. Finally, disconnect any wiring attached to the antenna before fully removing it from the vehicle.


What is one common function of an arthropod's antenn ae?

Arthropods with antenna use them for sensory functions, and commonly for the chemical sense (smell and taste). Antenna function differ for various species but often include detection of motion (vibration), touch, and heat.


How do you install power antenna mast Lexus sc 430?

To install a power antenna mast on a Lexus SC 430, first, ensure the vehicle is turned off and the antenna is retracted. Remove the old mast by unscrewing it from the antenna housing, then disconnect any wiring if applicable. Next, insert the new mast into the antenna assembly, ensuring it clicks into place, and reattach any wiring. Finally, test the antenna to ensure it extends and retracts properly.