0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the material for a M16 Bolt?
The M16 assault rifle's bolt and bolt carrier are made of steel.
How you find the pcd of flange?
PCD (Pitch Circle Diameter) is the diameter of a circle that goes through each of the bolt holes. You can find it by measuring distance from centre of one bolt hole to the centre of opposite end bolt hole...
What is m16 grade 8.8 bolt?
A bolt.
How do you measure lug patterns?
On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.
A carpenter has a bolt with the diameter 0.3125 inchesWill the bolt fit in hole made by a drill bit with diameter 0.3 inches?
if the diameter 5/16 inches then you covert the 5/16 into 0.3125 inches. divide 5 by 16=0.3125 which is a little bigger than 0.3! ;)
What are the materials for an m16?
The M16 assault rifle has a 7075 aluminium alloy receiver, steel barrel, bolt, and bolt carrier, and glass-reinforced polymer handguard, pistol grip, and buttstock.
What is the stock subwoofer size in a Oldsmobile aurora?
measure the diameter of the hole for the speaker/subwoofer and the distance to each bolt hole to asure you get the right subwoofer to fit properly.
Is the l96 better than the m16?
uh well there completly different guns...the m16 is a assualt rifle and the l96 is a bolt action rifle. m16 is probly the better choice if your trying to survive on a battlefield.
What is the indication that the last round has been fired on the m16?
the bolt will remain open
How much does a M16 bolt weigh in average?
2 1/2 ounces
What do you mean by gross diameter of bolt?
This would be concidered the largest diameter,dimension of a bolt.
How do you make a bolt fit into a larger hole?
I would get a larger bolt. I would get a larger bolt. If I wanted to make a bolt fit into a larger hole, I would use a SMALLER bolt than the hole.
