its either for a jamming check or so you can aim
Assuming you are talking about the handle near where the trigger is situated, the hole on the underside is for storing on spare dart which can be removed and used whenever you need it. I don't personally use it much; It's just one shot, and it can fall out, however it is useful for adding it into an unfilled 'Nerf n-strike clip system' dart clip.
No.
the Germany type is zebra type and no hole,America is the hole type hose clip
to store an extra dart
No. Nerf darts have a hole in the back which is inserted or loaded onto a post inside the chamber or barrel which keeps them in place. Bullets do not have that hole and would not fit into any Nerf gun. And even then, Nerf guns rely on springs and air for power. Real bullets are fired using an internal hammer which strikes the back and sets off a chain reaction inside the bullet, which releases it.
There is a small hole in the front of the drive, just small enough for a paper-clip wire. Straighten a paper clip and push it in the hole until the drive opens.
well that is a new one for me but i hopefully can help, i own on myself and will walk you through the repair process. first if the gun is modified then check that the dart is not caught in the air restrictor hole, then try to force the gun slide back a little bit. then if possible give the six shot clip a hard yank to try to force it out of the dart tooth. i will not be held liable for any damage done to your nerf blaster
Yes except for verizion iphones. iphone 4 have a small hole on the side use a paper clip to insert in the hole and the card will pop out. Other iphones have it on the top near the power button. Again use a paper clip to insert into the hole.
The main difference between the magnetic and the clip-ons are how they look. Clip-ons are okay for dangly, hoops, or large earrings. However if you want small earrings or studs, you should stick with magnetic earrings because the small clip-ons tend to look either childish or grandmotherly.
On the door of every CD drive there is small hole, about the size of a paper clip. This is a manual release. Gentle press the end of a paper clip or small wire into this hole, and the CD door will release and you can slide it gently open.
if you are talking about the hole in the bottom of some of the handles those are to hold an extra dart
Optical drives have a little hole in the front. Typically a paper clip is un bent and stuck in this hole to manually open the drive.