0
"ifconfig" is a command found in most *NIX operating systems (think UNIX, Linux, BSD, etc...). it's equivalent in Windows is "ipconfig". it is a command you call from the shell (not the graphical user interface) that allows you see/set IP configurations for a specific interface.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can you run Unix commands in uppercase?
On the off chance that the name of the binary / script is in uppercase, yes. But "ifconfig", "Ifconfig", and "IFCONFIG" are treated as three separate programs.
How do you get the IP address in Linux?
Run /sbin/ifconfig or on the terminal jst type: ifconfig -a
Find gateway address subnet mask Linux?
Use the 'ifconfig' command on your adaptor, or just 'ifconfig -a'
What linux command to display ip?
ifconfig
How can you check network parameters of the Linux system?
ifconfig
How do you set the IP address in Linux?
set the IP address with the ifconfig command use the syntax: ifconfig interface address netmask up view your network interfaces with the command ifconfig then for example to set address to 172.12.0.1 on the interface eth0 use: ifconfig eth0 172.12.0.1 netmask 255.255.0.0 up make sure you have root permissions to do this, either be logged in as root or preceed the command with "sudo". you don't have to specify the subnet mask if you don't want to, but it is generally recommended to do so.
What Ubuntu command is used to check network adapter settings?
ifconfig
How do you find IP addresses in Linux via command line?
ifconfig
How can you view and set wireless interface card settings from the command line on Unix systems?
The command 'ifconfig' is powerful. It allows you to configure any network interfaces attached to your computer, assuming you have the appropriate driver. To scan for wireless access points, try: $ ifconfig wlan0 list scan To connect to a specific SSID, try: $ ifconfig wlan0 ssid SSID_GOES_HERE
How do you enable LAN card Ethernet - eth0 in Linux?
ifconfig eth0 up
How would a technician permanently change the IP address of an Ethernet card on a Red Hat Linux PC?
Command to change the IP address on Linux is ifconfig.Run ifconfig to find the interface name for the connected Ethernet card. If there is only on ethernet card present on your system then the interface name would be eth0. If there are more than one Ethernet cards present on your machine then they interface names will be ethn.Once you have figurred out the interface name then ifconfig command can be used to modify the IP address$ ifconfig eth0 upeg$ ifconfig eth0 192.168.1.100 upWould assign new IP address to eth0
Which UNIX and Mac command displays information relating to IP configuration of an end system?
ifconfig -a
