answersLogoWhite

0


Best Answer

Engineered wood.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is it called when you cover manufactured board with a thin layer of plastic?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is it necessary to cover the edges of a manufactured board?

I think it makes the board stronger


What is a piece of thin wood used to cover a roof?

The thin piece of wood used to cover a roof is called ply board or deck board. Plyboard is a sheet material manufactured from thin layers or plies of wood veneer that are glued together.


What is poly board?

A board with an outer, plastic-like cover of polyethylene or polypropylene. It s usually a heavy, durable beginner board.


Where is the dash board fuse in a 1993 Lincoln town car?

Under Left Side Dash Board Under plastic cover .....:)


What is the plastic cover called over the timing belt?

Timing belt cover


What is a a thin piece of wood used to cover a roof called?

The thin piece of wood used to cover a roof is called ply board or deck board. Plyboard is a sheet material manufactured from thin layers or plies of wood veneer that are glued together.


Where is the fuse board in a vw transporter?

Underneath the steering wheel on the left side pasted to the firewall. It has a plastic cover


Where are the fuses in a 1990 Chevy S-10 blazer?

Left side bottom of Dash Board, with a Plastic Cover


Where is the wiper motor pulse board located on a 2003 Chevy silverado?

Behind the plastic cover on the wiper motor.


What is the plastic cover that is under the engine of a 2006 Dodge Daytona Charger RT called?

Plenium cover.


Where is the pulse board on a 1998 Chevy s10 wiper motor?

It is attached directly to the wiper motor. Remove the three small screws that hold a black plastic cover on the wiper motor. The pulse board is under that cover. Most of your wiper motor problems are from a faulty pulse board.


What are the steps to remove a 2003 Mitsubishi Eclipse dash board?

Remove the plastic cover going around the board. It sits on clips. After you will see 4 screws holding the board. Remove them too. Pull out carefully the board, disconnect 3 wire harnesses.