if you mean plastic inner cover use a craft knife round the edges, and stick it back on when done
If it a mechanical lock none.
it opens by the door key passenger side lock and unlock twice and then open the gas door stupid right
the atoms dissolve with the atoms and the molecules to lock the sugar and salt / lock in to make the crystals
refers to an opening in the wall, and everything that is installed in that wall to provide a "rated" assembly. This would include the door, the frame, the frame anchors, the hinges, the door closer, lock sets and other hardware attached to the door.
Most likely rust has settled in. The best way is to remove the door panel and spray all the parts with either a rust spray, or Wd40. If you cannot open the door to get the panels off, then roll down the window, and use an oil can and squirt oil all over the lock parts, and work the lock at the same time. Might take some time, and put a piece of carton under the door to catch all the oil. Good luck.
i need to see a pic of your problem before answering
just cut the rubber (glue) around that cover do you mean theguide rail lock cover? if so... working at the rear edge of door remove two screws that secure it to the door and manipulate it out of the hole.
Go to a wrecker and get a used lock from there.
just remove the door trim then carfully remove the plastic film so u can replace it...now u can remove the door lock....once u remove its retaining clip it will puch out.
Sounds too complicated to even suggest. I tried to do mine 2 weeks ago and it cost me more time and money to get the job repaired. I used a specialit car locksmith in the end called The Auto Locksmith www.theautolocksmith.co.uk Maybe you are better then me and can repair a faulty fiesta lock yourself. www.theautolocksmith.co.uk/DamagedLocks.html Good luck
Remove the door panel, remove the lower side of the window channel, remove door lock mechanism. remove the black plastic cover help by 2 screws, then remove the black plastic door lock unit, with the connector on it, and replace. You can pry the unit open and replace the electric motor in it.
No, it has the normal manual lock for each door and the boot
remove plastic cover next to driver door handle using the key in remote fob and then insert key into lock.
A shotgun, a strong crowbar and a lot of upper body muscle.
if u look at the top of ur card u use to start the car u will normally find a key inside it wich pulls out and on the passenger door handle were the lock is meant to be is a plastic cover that hides a door lock #
To take the drivers side lock out of a 1990 4runner you will first need to remove the door cover panel. Once the door cover panel is removed you will have access to the lock and can replace it.
if it is the circular metal bracket then you need a nail punch in one of the holes using a hammer knock it in the direction of the metal tabs to release. refit the opposite way