0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the limit of linearity range?
Limit of Linearity is the concentration at which the calibration curve departs from linearity by a specified amount. A deviation of approximately 5% is usually considered the upper limit. Common at higher concentrations.
What is the need for trapezoidal waveform for linearity correction?
This would keep the voltage across the inductance a constant, and corrects the non-linearity problem.
Linearity is how much important in method validation?
its important for recover the calculation equation and for improve linearity equation (pears low )
What is terminal linearity?
Terminal linearity is when there is no flexibility allowed in the placement of the straight line in order to minimize the deviations ( or non-linearities). The straight line must be located so that each of its end points coincides with the device's upper and lower range values. This means that the non linearity measured will be larger than that measured by the independent linearity definitions.
What is linearity error?
When a function or given data set differes from a liniar curve fit. the difference between the data and a linear curve fit is your linearity error
How non linearity property works in audio spotlighting?
GodIsGreat
Is superposition theorem concept based on linearity elements?
yes
The capillary tubing has a uniform bore in a mercury thermometer?
yes ! to insure linearity
Is it necessary to test for the linearity assumption when using ordinal scaled variables?
Yes, it is.
What is need of scaling in digital signal processing?
saturation arithmetic eliminates limit cycle due to overflow, but it causes undesirable signal distortion due to the non linearity of the clipper.In order to limit the amount of non linear distortion , it is important to scale the input signal and the unit sample response between the input and any internal summing node in the system such that overflow becomes a rare event.
Difference between linearity and range in analytical method validation?
The previously recorded answer in inaccurate on several levels (see below for quotations of previous repsonse)Linearity is the correlation of a regression line. Range is typically derived from linearity. Range implies that the method developed corresponds to the "range"between 80-120% (ideally) of the expected sample range (concentration, wt. etc). For content uniformity, range is expected to be 70-130% of the test concentration. These are guidelines governed by ICH Q2 R1 (International Conference for Hamonisation).In terms of HPLC method development:LOQ is the smallest amount that will give a S/N ratio of 10 meaning this is the smallest amount you may give a numerical value with confidence. TYPICALLY, THE LOWER RANGE (AND USUALLY LINEARITY) IS LOQ.LOD is the smallest value that will give an S/N ratio of 3, meaning you can say the specific compound is there qualitatively, but not quantitate the compound.Previous:"The range is any value that lies between the limit of detection (LoD) and the limit of quantitation (LoQ). Where the LoD is the lowest concentration that can be accurately measured and the LoQ is the highest concentration that can be accurately measured.Linearity describes the correlation to a regression line that has been fit to the data that. For some nice pictures to explain this see regression line at:"
What is demerit of balance slope detector for FM receiver?
poor linearity, difficult in tuning and lack of provisions for limiting
