A fillet weld is a triangular weld with sides of a width, w by w . The throat is the thinnest portion, which is w divided by square root of 2. The throat thickness is used in stress calculations
It means, that the Weld Bead/ Weld Metal must be very well blended with the Parent Material/ Base Metal. There shall be a smooth transition between the Base Metal and the Weld ( Face or Root ) Reinforcement without any sharp or sudden changes ( e.g. Sharp Edges- commonly seen on the weld toes-, Peaks, Metal Inclusions- filler wire/metal/material inclusion-, dents, sudden variations or deviations in the weld dimensions...). ..You're gonna be able to see more of this requirements in the aerospace industry. The Chosen One
The size of the welding rod needed to do the root pass should be the same as the root gap, although in practice, the most common root gap is 1/8" so that the size of the rod to do it is also 1/8".
The last bead of a groove weld, it can be made with a weave motion back and forth, or with stringer beads tied into each other.
A butt weld is a weld made between two straight cut profiles , a socket , or plug weld is made between a surface and a hole.
To find the root opening on a groove weld symbol one must measure the depth of filling for plug & slot weld. Rhianna Berriman
It is the first pass in a multiple weld joint.
It is the first pass in a multiple weld joint.
root pass
To find the root opening on a groove weld symbol one must measure the depth of filling for plug & slot weld. Rhianna Berriman
we cant weld p-91 withour purging bcoz otherwise oxidation will occur
A fillet weld is a triangular weld with sides of a width, w by w . The throat is the thinnest portion, which is w divided by square root of 2. The throat thickness is used in stress calculations
leg,toe,face,throat,root joint
First, Butt-weld is short for a butt groove. Welding in a butt-groove starts at the throat of the butt-groove. The first weld point could be a tack-weld: holding the two materials to be welded together. The throat is measured and filler metal and electrode are determined to create the root pass.
the root opening is the distance between joint members at the root of the weld before welding. the root opening must be accurate so that excess welding is not necessary.
I am not sure but I would assume two things about joint design and its effect on the weld and visa versa: penetration and overall strength of the weld would depend greatly on what grove you are welding in or on and the amount of distortion would vary greatly depending on how large of root opening and weld size etc.
What is a word root? If you meant root word, the answer is "marvel". "ous" is a suffix.