0
What is a normal operating pressure for a jacuzzi sand filter for an above ground pool?
Wiki User
∙ 15y ago
What is a normal operating pressure for a jacuzzi sand filter for an above ground pool?"
Wiki User
∙ 15y ago
Wiki User
∙ 16y agoThere is no correct answer to this question. every application is different.
Wiki User
∙ 13y agoIt will usually vary on pump size, filter size, and total feet of head but a psi between 8-15 on a clean sand bed is pretty common.
Wiki User
∙ 12y ago15 psi
Add your answer:
Earn +20 pts
Why is there sediment in your well water?
There is often sediment because it comes out of the ground and up a steel pipe. Fit a sediment filter at the pressure tank, it's very easy.There is often sediment because it comes out of the ground and up a steel pipe. Fit a sediment filter at the pressure tank, it's very easy.
What should you do if you have an above-ground pool with a sand filter and the pressure gauge is only reading at 5 but you changed the sand in the filter and it still won't raise the pressure?
You may need a new pressure gauge. They are inexpensive and can be found at any place that sells pool products. OR That may be all that you are going to get out of the system you have.
How often should you backwash a sand filter on a above ground pool?
Sand filters usually have a pressure gauge in front of them indicating the back pressure before the filter.When the filter needs to be cleaned this pressure gets high. usually it has a red section on the gauge. When it hits the red it is time to think about back washing. If the gauge does not work as so often happens with these things. you can usually judge it from the lack of suction coming from the filter. After backwash you will note the pressure will be down and the suction will be up.
Is being in a Jacuzzi bad for you?
Being in a jacuzzi or spa can be very relaxing and enjoyable, but it can also be a breeding ground for viruses and bacteria if not maintained properly. Always be sure that some kind of disinfectant (chorine is always good) is being used to disinfect the spa, and people should always rinse off before entering. They can also kill thousands of sperm if you stay in for more than 15 minutes.
Which companies supply jacuzzi spas?
This question depends on where the one asking the question is located. Jacuzzi spas may be purchased from independent retailers in your local area. They will be able to give you advice based on ground conditions and will also be accessible to you should something go wrong.
How do you repair an above ground pool filter?
Install a new filter
Where is the fuel filter located on a 1993 Mazda 626?
The fuel filter is located underneath the air filter box. It is quite awkward to get to unless you complete remove the air filter box. Be sure to open your fuel tank to relieve pressure before unhooking the fuel lines and put a pan on the ground to catch the fuel.
How do you relieve the fuel pressure to change the fuel filter on a 1999 CRV?
You don't. Just make sure the key is not on (best to not have it in the ignition at all) When you loosen the fuel filter, the pressure will relieve by leaking on the ground. Expect less than a half cup of fuel to leak out from pressure. The remainder fuel will be from inside the filter housing. Get ready to get your hands soaked in gasoline. Dont listen to that guy. You can relieve the gas pressure by simply open your gas cap and leave if off the entire time when you're working on your fuel filter. Some fuel will still leaks out from the fuel filter but at least it's not going to spray on your face.
Can you use an in-ground filter on an above ground swimming pool?
Sure
What is the pipe that comes out of the ground makes a you-turn and ends with an open end used for?
It sounds like it may be the pipe that the back wash water comes out of when the filter is on back wash. A: The above is wrong. That pipe is for air suction to the spa jets thus giving the "Jacuzzi" action or aeration at the spa jets. k
Why is sediment in your well water?
There is a certain amount of sediment in all well water - it is coming out of the ground remember. Every well should have a sediment filter before the pressure tank.
The oil pressure on a 73 307 V8 falls as you accelerate but increases when you let off the gas why?
Change the oil and filter. Install an AC/Delco filter and the correct amount of 10w30 oil. If the problem still presists, have an oil pressure test run. You may also have a defective oil pressure sending unit, loose wiring, or the wiring may be frayed and touching ground. Check the wiring throughly going to the oil pressure sending unit.
