i wish i knew
Just take the wire that go to the seat and join them together. ( THIS IS A SAFETY FEATURE IF YOU BY PASS IT WHEN YOU GET OFF THE SEAT THE LAWNMOWER WILL STAY RUNNING!!!!!!!!!!!)
the solenoid switch on a riding lawnmower is located at the bottom of the carburetor bowl, its used to turn the fuel on and off. some older models don't have the solenoid. Also,there is another solenoid switch for the starter i think that's the one you want, that's located under the gas tank on the right hand side on the frame. good luck
The kill switch wire is either disconnected or broken. Follow the wire from the OFF position of the ignition switch toward the engine where it connects to another wire coming from under the engine shroud. If everything is okay between the switch and where the two wires connect, you will have to remove the engine shroud to look there.
Just switch off and switch on- it works
A SPST switch is the type used for turning the lights on and off in your home lighting systems. It is just basically just an on - off switch.
you replace the spark plug If after replacing the spark plug you still have no spark you may want to check depending on year and model of lawnmower: - wire to kill switch might be shorted. -Take flywheel cover off and clean dirt and rust off flywheel and coil -if it has points and condenser you will have to pull the fly wheel and replace them and reset points then put back together.
I think a electric lawnmower would be cheaper because current usage goes off the amount of amps and if you have a lawnmower that has a low voltage then it would cost you less.
unnderneath the lawnmower there should be 4 main bolts near each corner of the motor theese need to come out
it is both you just switch the switch to off to make it single and switch it on to make it auto
On the back of the switch or on the bottom I forget now ther is a little button push it in and pull the light switch shaft off. take the panel off in front of the switch. take the nut off holding the switch in . after you put the new switch in just push the headlight switch shaft back in. I just want to say you might not have to take the panel off in front of switch
switch in phyisics is used to control something, like in a circuit yu have a switch to turn it off and turn it on.. just like a normal light switch. so the answer is to control a thing.(turn it on and off)
On the top it has a switch that says on/off so just switch it to on :]