0
I think you mean 'single-phase supply', rather than 'phase supply'.
All high-voltage a.c. transmission and distribution systems are three-phase systems. This is because, for a given load, a three-phase system uses less copper than a single-phase system. Three-phase generators produce three 'phase voltages', each displaced, by 120 electrical degrees. These voltages are produced in three windings which are electrically connected in what is called a 'delta' configuration, with each 'corner' of the delta connected to the transmission system by 'line' conductors.
Three-phase systems are either 'three-wire' or 'four-wire' systems. Generally, three-phase, three-wire, systems are used for high-voltage transmission and distribution, whereas three-phase, four-wire, systems are typically (but not always) used for low-voltage distribution. Three-wire systems comprise three conductors called 'line conductors'; four-wire systems comprise three 'line conductors' and a 'neutral conductor'.
Depending the voltage standards used in the country in which you live, a single-phase supply is obtained either by connecting single-phase load between any two line conductors, or between any one line conductor and the neutral conductor.
What else can I help you with?
How do you start a three phase motor to a single phase power supply?
You don't. A three phase motor will not start unless it is connected to a three phase supply.
What is the requirement of three phase to five phase transformation?
If you want a five-phase supply you need to start with a three-phase supply and a transformer that has 15 symmetrical cores. But why would one need a five-phase supply . . three is enough.
How is a three phase agricultural motor used when there is no power supply?
With no three phase power supply you can't use a three phase motor of any kind at all!
What is the difference between three phase load and phase supply?
How much current equipments are drawing from three phases (combined or individual) is called three phase load and how much supply we are getting from source is called three phase supply. Ex. In INDIA single phase supply is 220 volt ac with neutral. So in three phase supply all RYB phases should be 220 volts ac with neutral individually. If we calculate with phase to phase than it shoulb be 415 volts ac.
Can a single phase supply be used in a three phase supply?
No, a single-phase supply cannot be directly used in a three-phase system. The voltages and phases are different, so additional equipment such as a phase converter or transformer would be needed to convert the single-phase supply to match the requirements of the three-phase system.
Can you give single phase supply to three phase device?
No.
How would DC be obtained from a three phase supply?
By using a three-phase rectifier.
What circuit you can use to run three phase motor?
It must be a three phase supply service to run a three phase motor.
Where are three phase transformer systems used?
Any where that a three phase supply distribution is needed to operate three phase equipment.
Why Scott connection is used to convert three phase to two phase why cant you take two lines from three phase circuit?
In a two-phase connection, the phases are displaced by 90 degrees. Two lines (not 'phases') of a three-phase system will provide a single-phase supply, not a two-phase supply.
When would a three phase supply be preferred over a single phase supply?
Bcoz in single phase if supply is interrupt or any trouble there is no power .but in 3 phase if 1phase supply gone we can manage it by other 2 phases
How much will it Cost to upgrade an electricity supply from phase 1 to phase 2 for a Melbourne home?
If you are asking whether it is possible to upgrade from single phase to two phase, then you should understand that a two phase system is archaic and will not be available from your electricity supply company. If you are asking whether your company can supply two lines (out of three) it's quite unlikely -they will normally supply single phase or three phase! You can likely upgrade to three-phase if you have a reason to do so -e.g. to operate three-phase motors. As for the cost -you'll have to check that our yourself!
