The pipe coming off of sump pump that goes outside or if allowable, a drain line.
It is common practice to specify the pump suction line one size larger than the pump discharge line in order to increase the Net Positive Suction Head available (NPSHA) to the pump. A smaller suction line the same pipe size as the discharge line would result in more pressure drop in the suction line and reduce the amount of head available to the suction side of the pump. This in turn would result in an operating point closer to cavitation of the pump.
In boiler feed pumps usually the discharge pressure is 20 to 30 times tie suction Pressure so to protect the pump balancing line is given from discharge to suction.
A sump pump discharge line should run as far from the foundation walls as possible.
the above was the answer the gas line inside the tank had come off even though the crimping clamp was still on it This was the line from pump discharge to the filter
yes, unless local codes prohibit it.
Possibly the impeller needs cleaning or a blockage in the line
Yes, the discharge line from the compressor can be hot.Yes, the discharge line from the compressor can be hot.
centrifugal pump should be fill with liquid to built discharge pressur.chemist.yasser.Naguib
This is a job for a qualified plumber, as there are various factors that have to be taken into account which cannot be made.
Boiler feed pump's suction pressure be aprox. 15Kg/cm2 and discharge pressure be 180Kg/cm2. So the balancing line balance the pressure and protect the boiler feed pump. my quastion is that what is the working principal of balancing leak off
if the discharge of centrifugal pump is closed the pressure is built up in it and after some time it will burst up