0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What rhymes with scope it out?
Some words that rhyme with "scope it out" include "dote about," "note devout," and "coat throughout."
What is your scope and responsibility for rectifying risks in hairdressing?
to asses risks and note down injurys or hazards that have been noticed or have happened
Write a note on the scope of human geography?
human geography is a synthetic study of relationship between human societies and earth surface.....
How much eye relief does one need when mounting a 4-15 scope on a power master 760?
That will depend on the scope and your eyes- but is ABOUT 3.5 inches. (Distance between your eye and the rear lens of the scope) It is the distance where you see the full image in the scope. You adjust it by sliding the scope forwards or backwards in the rings before tightening them down so that it fits YOU when holding the rifle in firing position. Please note- failure to pull a heavy recoiling rifle in TIGHT to your shoulder will result in a cut over your eye from being whacked with the scope.
What is the noscope song lyrics?
He got a no scope he didnt scope his gun no no, no scope was involved He got a no scope and now hes killed someone their dead he shot him in the head He got a no scope what a wondrous feat what a marvelous kill i concede What do you get when you get real stressed quickly pull the trigger and hope for the best call them a noob and hump their chest I think you just got a no scope And where did your daddy go He abandoned you when you were only seven years old And living on the streets is cold you beg for food and money You beg for food and love You beg for food and care again No no no no no no no no no no Scope scope scope scope scope scope scope scope scope scope No no no no no no no no no no Scope scope scope scope scope scope scope scope scope scope He got a no,no,no scope
How to install a rifle scope?
Here's the basics on mounting the scope on a rifle. ( Assuming you have a scope mount on the rifle.) 1. Place the bottom half of the scope rings on the rifle first (Without the scope attached.) 2. Place the scope on the bottom half of the rings and adjust the scope mounts to comfortably fit your eye. When adjusted, tighten down the bottom half of scope rings to the rifle mount. ( The scope should have one cross hair adjustment at the top and one on the right.) 3. Place the scope in the rings and then put the top half of the rings on. Tighten them down, but not VICE tight, just loose. You still want to move the scope some. 4. Look through the scope and align the cross hairs level with the rifle barrel. The Vertical line should be straight up and down at a right angle with the barrel. 5. when you have the scope adjusted to your eye and the barrel of the rifle, tighten the top scope rings in a crisscross pattern a little at a time. Don't vice one down then go to the next one. Do it a few turns on each one until they are tight. A final note. If you have a small screw hole and screw at the back end of the scope mount (on the rifle) you may want to place the rear scope ring against that screw. This is a scope stop. This will keep the scope from moving back from the recoil. Some scope mounts have a long pad at the rear of the scope mount that acts the same way. It's usually necessary on high powered rifles not 22's.
What is the invincibility code for 'Batman Begins' for PlayStation 2?
{| ! scope="col" | ! scope="col" | | ! scope="col" | ! scope="col" | | |}
What are the scope in geography after graduation?
scope of geography after graduation
Can the XS-B4 air rifle support a scope?
If it has a scope rail or grooves for a scope mount then yes it will support a scope but you may need a scope stop to keep it from moving.
How is the scope for Msc in TQM?
No Scope....................
What is the scope after problem manager?
scope
How do you scope a rifle?
You are asking this question in the Shotgun category, so I must say that you don't scope a shotgun. Here's the basics on mounting the scope on a rifle. ( Assuming you have a scope mount on the rifle.) 1. Place the bottom half of the scope rings on the rifle first (Without the scope attached.) 2. Place the scope on the bottom half of the rings and adjust the scope mounts to comfortably fit your eye. When adjusted, tighten down the bottom half of scope rings to the rifle mount. ( The scope should have one cross hair adjustment at the top and one on the right.) 3. Place the scope in the rings and then put the top half of the rings on. Tighten them down, but not VICE tight, just loose. You still want to move the scope some. 4. Look through the scope and align the cross hairs level with the rifle barrel. The Vertical line should be straight up and down at a right angle with the barrel. 5. when you have the scope adjusted to your eye and the barrel of the rifle, tighten the top scope rings in a crisscross pattern a little at a time. Don't vice one down then go to the next one. Do it a few turns on each one until they are tight. A final note. If you have a small screw hole and screw at the back end of the scope mount (on the rifle) you may want to place the rear scope ring against that screw. This is a scope stop. This will keep the scope from moving back from the recoil. Some scope mounts have a long pad at the rear of the scope mount that acts the same way. It's usually necessary on high powered rifles not 22's. You most certainly can and should scope your shotguns as long as your state allows the use of scopes on them. I have scopes on all of my shotguns, and especially my slug gun!
