0
As per the Italian standard, the standard height of the wall hung water closet is 420mm, Table top basin is 850mm
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Average chair height?
The average height of a chair is between 16 to 18 inches for adults. This is found to be the most comfortable height for a seat.
How do you replace ballcock?
Turn off the water and drain the tank. Sop up excess as needed. Remove old ballcock and install new one. Connect chain and verify slack, but not too much slack, and that the chain will not catch an anything. Turn on water and let tank fill. Flush several times and verify correct operation. Double check chain. Sometimes, the ballcock seat is bad. You can replace it, but that is usually difficult and occasionally gets out of hand. They make a ballcock with seat replacement. The seat sits on top of the old seat using some kind of putty. Ususally, you remove old ballcock, clean and dry seat, apply putty bead to new seat, and press on, following any specific directions in the kit. In all cases, you need to check the minimum drain level. There is a cup on the back of the ballcock that lets you adjust how far down the water goes before the ballcock closes. This can save water. Set it to where the flush is correct for your application.
How do you remove toilet seat with rusted bolts?
Rusting bolts normally indicates that the bolts are brittle. Taking a pair of water pump pliers and squeezing really hard will most of the time break the rusted bolt so you can remove the toilet seat. Otherwise depending on the type of toilet seat installed, you can drill a hole right through exactly where the rusted bolts slot in, so helping you remove the toilet seat.
Why is my toilet seat not aligned with the toilet?
Misalignment may result if you mixed the styles of round and elongated toilet with a seat of the other type. To correct this, obtain the properly shaped seat. Use the link below to see a comparison of the two shapes of seat. If the seat is the correct type but is not aligned, the fasteners that hold the seat in place might have been tightened down before aligning the seat with the top of the fixture. Loosen the fasteners, align the seat, and retighten those fasteners.
Why is there a gap in the toilet seat?
To Prevent The Chance Males From Splashing On The Seat.
What is standard height of water closet seat in Singapore?
The stander height of water closet seat is 14 to 16 inches high. Wilson fink
What are toilet seat height standards in the US?
The height of a standard toilet seat is 14" from a furnished floor.
Standard restaurant booth height?
The standard restaurant booth height to the seat is 30 inches. The height of the backrest varies and depends on the style that one chooses. There is no standard for this.
What is the standard seat height on a lounge chair?
18 inches
Why is the standard toilet seat always lower in height than the standard dining room seat?
Because the lower height creates a better angle to facilitate defecation in a clean manner.
What is the standard dining chair arm height?
8-10" from the top of the seat.
What is a standart height of a bar stool?
There's no single standard, but the most common heights for bar stools are 30 inches and 24 inches (seat height).
What is the difference between seat height and overall height on a dirt bike?
Seat height is the seat And overall height is to the tallest point on the bike, like the bars
What is the seat height for a 1986 Kawasaki KLR250?
Seat height: 33.7 in
What is the seat height of a 1200 goldwing?
The 1200 and 1500 had a seat height of 30.7" until 1995. They lowered the seat height to 29.1" in 1995.
Do wooden counter stools come in more then one standard height?
Wooden counter stools vary from as little as 18 inches in height to 26 inches. It is said that there should be 9 or 13 inches between the height of the seat and the height of the table.
What is the seat height of a Yamaha YZ 80?
The seat height on a 2001 Yamaha yz80 33.6 in.
