They are inertia and momentum. If an object is in motion it tends to "try" to stay in motion, and an object at rest does the same to stay put. The forces still act on it, although the forces are slightly weaker.
because with out it, things wouldn't stay put,cars wouldn't stop and alot more
An electromagnet makes a great door lock. The steel in the door will stay put until the electromagnet is turned off.
If you leave it in a pile, it will get wrinkled, stay wet, get musty and take a long time to dry.
If no force acts upon an object at rest it will just stay there. Example: Lets say you put an appple on a flat table. The apple stays still when you don't touch it. If you touch the apple, it will move. If you don't touch the apple, it will just stay there.
No, not unless summit racing makes a special adapter plate to do it.
put vehicle in 4wd seee if the driveline out of t-case is spinning if so ur t-case is owrking but hubs arnt locking into 4wd. that will get u 1/2 way there
shifter
With the engine off, press and hold the odometer reset pushbutton. Start the car. Keep finger on odometer reset pushbutton until "oil life" message starts flashing. Release the button.
1. Turn the radio on. 2. Press BAND to select FM1, FM2, AM, or XM1 or XM2. 3. Tune in the desired station. 4. Press and hold one of the six numbered pushbuttons until you hear a beep. Whenever that numbered pushbutton is pressed, the station that was set will return for that pushbutton. 5. Repeat the steps for each pushbutton.
orange and pink
stay, stay put, stay behind, linger, wait, hang about
Stay where you are Do not move Do not go anywhere and so on ...
they put up
Stay put: You could use this on the phone 'stay put and il get back to you' Obviously they are allowed to move, but it shows them that you are trying to find an answer for something. Stay still: Would normally mean physically. You could be talking to your dog 'stay still' which would mean it wasnt allowed to move.
The main contact controls the load current to the motor, whereas the auxiliary contact is part of the control circuit -usually connected in parallel with the 'on' pushbutton switch to maintain the control circuit in the energised state, once the on pushbutton has been pressed.
1. Remove Plastic cover on interior side of lock 2. Press Black Pushbutton one time 3. Enter User Code on keypad 4. Press Lock Button on keypad 5. Press Black Pushbutton one time