0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How is the capacity of a screw compressor controlled?
Capacity control is the process by which the flow of the discharged gas from the compressor is controlled. This can be accomplished by several method. 1. Controlling the speed of the compressor. 2. Controlling the clearance of the compressor. 3. Throttling the suction valve. 4. Suction valve unloader.
What is the function of Suction valve?
the suction valve is transfered fluid one pipe to another pipe at a specific pressure and quantity.
Why does inlet valve opens before the beginning of suction stroke?
for completely entering of fresh charge the inlet valve opens before suction stroke
Where is the suction recharge valve 2000 Ford Focus?
where is the suction recharge value on a 200 ford focus
Where must a suction - line drier be placed in a heat pump after a motor burnout?
Between compressor suction and reversing valve,also called true suction.
Where must a suction line drier be placed in a heat pump after a motor burnout?
Between compressor suction and reversing valve,also called true suction.
Where is the freon low side on 2006 dodge 1500 truck?
The low side is from the H-valve or orifice tube to the suction side of the compressor.The low side is from the H-valve or orifice tube to the suction side of the compressor.
In what position is a suction service valve when operating?
middle position
How Air suction valve work in Bike?
Air suction valve connected between air filter and exaust manifold.it converts carbon monoxide to carbon dioxide. sanjivkumar p kmnr kfi
What are symptoms of a bad PCV valve?
valve should rattle when shook, and when engine is started it should have a good suction.
What are the procedure for pumping down a Split ac system?
Connect your refrigerant gauges, jump out the low pressure safety control, start the unit and after it has settled out, front seat the liquid line service valve. Monitor the suction and discharge pressures when they both reach 10``wc. Shut the machine off and quickly front seat the suction service valve.
Your ingound pool has to much suction you cannot move the brush on the bottom of the pool even with the valve almost fully open?
You can get a by pass valve that will alleviate some of the suction by taking water into the hose at another point.
