answersLogoWhite

0

What is switch purpose?

User Avatar

Anonymous

9y ago
Updated: 5/13/2022

A switch is used to make or break an electrical circuit.

User Avatar

Bailee Schulist

Lvl 10
3y ago

What else can I help you with?

Related Questions

Where is the multi-purpose switch for a 1995 olds aurora?

A multi-purpose switch is the blinker- high beam switch on the stearing coulm of the car.


What is a switch's purpose?

A switch is used to make or break an electrical circuit.


What is the purpose of the red wire on a light switch?

The purpose of the red wire on a light switch is to carry electrical current to the switch, allowing it to control the flow of electricity to the light fixture.


What is the purpose of the red wire in a light switch?

The purpose of the red wire in a light switch is to carry electrical current from the switch to the light fixture, allowing the switch to control the flow of electricity and turn the light on or off.


What is the purpose of a push switch?

The purpose of a push switch is to cause changes in an electrical circuit to activate an event, such as turning on and off devices such as microwaves.


What is the purpose of a snap switch in an electrical circuit?

The purpose of a snap switch in an electrical circuit is to control the flow of electricity by opening or closing the circuit when activated.


What is the purpose of the common wire on a light switch?

The purpose of the common wire on a light switch is to provide a return path for the electrical current to complete the circuit and allow the switch to control the flow of electricity to the light fixture.


Does closing a switch allow charges to flow in a circuit?

Yes, that's basically the purpose of a switch.


What is the purpose of the common wire in a light switch circuit?

The purpose of the common wire in a light switch circuit is to provide a return path for the electrical current to complete the circuit and allow the light to turn on or off when the switch is toggled.


What is the purpose of the red wire in a light switch installation?

The purpose of the red wire in a light switch installation is to carry electrical current to control a specific function, such as a separate light fixture or a three-way switch setup.


What is the purpose of pressure switch?

the purpose of the pressure switch is to insure that a draft is established with the flu, this switch is normally open and as the inducer ramps up the pressure switch closes at predetermined set point, upon closing this sends signal to board to energize HSI and ultimately gas valve.


Does a 2001 doge neon have a low oil switch?

It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.It has an oil pressure switch whose only purpose is to turn an indicator light on if the oil pressure is too low. The switch is located on the back of the block.