Depends on what time it currently is.
Say its 4:00. T-30 minutes would be 3:30.
The T30 Heavy Tank was a tank used by the United States during World War II. They were made to compete with the types of tanks that the Germans were using.
yes
Yes you can. I have a generic 1GB SODIMM in my T30 for almost a year. Full capacity is reported by BIOS, speed is good and I have had no issues
T30, 2 of them
press Shift and ScrlLk at the same time.
http://www.doctorzebra.com/prez/t30.htm
The basic initial specifications of the IBM ThinkPad T30 include an Intel Pentium 4-M 2.0 GHz processor, a minimum 256 MB memory, a 60 Gigabyte hard drive, an AGP 4x graphical processor, and a plug-in CD/DVD-rom drive.
its not a hex,,,it`s a torx t30 i believe
The German Maus was a super-heavy tank that was designed for armored superiority, fielding a 128 mm gun. But it was impractically slow (8 mph). The Maus was never completed.The T30 was only finished after the end of World War II but could have inflicted damage on a Maus with its oversized 155 mm gun. The T30 had lighter armor but was considerably faster at up to 22 mph.The T30 today is considered a "tank destroyer" and the Maus was not the largest tank that Nazi Germany designed. The biggest tank was called the Ratte (Landkreuzer P. 1000 Ratte) , five times the weight of the Maus at over 1000 metric tons. This proposed Super Tank would have mounted twin 280mm naval guns, as well as adopting marine diesel engines for its motive power.
You need to buy a Star Bit Set (Torx) I think its T30 at the rear of sump it was on my 05 eco 1L David
To remove the headlamp you have to reomve the front bumper, for this you will need a torx 20 and 30 driver and a flat head screw driver. Unclip the front grill, looking down at the bumper on the left and the right there are 2 t30 screws that need to be removed.on the left and the right of the grill there is the same (2x t30) . On the bottom of the bumper, remove the left and right vent , there will be a t30 screw under each, the vents/grills will pop out u may need a flat head screw driver. under the wheel arches there are 4x t20 screws on both sides remove these and the bumper will drop. then simply remove the head lamp 2 t20 screw on the top and 2 at the bottom
The grill has to be removed first, then remove the painted trim below the headlamp, finally remove the screws holding the headlamp. All screws are torx drive. t20, t25, t30.