65 FT/LBS.
Start at 30 FT/LBS and use the proper torque sequence -- start in the middle and work your way to the ends in a circular pattern and torque all 17 bolts to 30. Then repeat at 50 FT/LBS. Then finally repeat one more time and torque to 65 FT/LBS. There's usually a torque sequence picture on a sheet included with the head gaskets when you buy them (at least with Fel Pro gasket sets), if not just do as stated above (or look in a manual) and start in the center and work your way to the ends evenly. Make sure the threads are clean before you start. Also recommend using a dab of RTV silicone on the bolt threads to lubricate them and also to seal them as they do go into water jackets.
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
18 ft lbs.
The 1987 Kia 1.8 liter engine had bolt torque specification is 120 pounds. The camshaft bolt torque specification is 90 pounds.
The Lexus cylinder head bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50 pound intervals.
The 1997 Geo 1.0 leader engine cylinder head bolt specification is 120 pounds. The camshaft bolt torque specification is 90 pounds.
The 2002 Kia had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
The Ford 3.0 liter cylinder head bolt torque specification is 150 pounds. The cylinder head bolts should be torqued in 50?æpound intervals.
The 1995 Pontiac sun fire cylinder had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
The cylinder head bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
The cylinder head bolt torque specification is 160 pounds. The cylinder head bolts should be torqued in 40 pound intervals.
The 1990 Ford Festiva 1.3 liter engine cylinder head bolt torque specification is 125 pounds. The cylinder head bolts should be torqued in 25 pound intervals.
The engine cylinder head cover nut has a torque of between 7 to 9 foot-pounds. This measurement specification also applies for the '80, '81, and '82 Z50R builds.