13 mm
4l60e deep or shallow pan, or 4l80e, (depending on the bolt pattern on bottom of tranny, auto zone can tell u the bolt patterns to what tranny)
17 bolts. The pan is symetrical left to right and mostly rectangular except for the rear corners which have a rounded indentation.
It has the 4L80E transmission in it. And the only one that you can put in it is a 1996 4L80E, no other year will bolt up.
It will bolt up but the wireing harness on the 1500 / 1/2 ton will not plug into the 4L80E transmission, there for it won't work. The 4L80E transmissions are for the 3/4 ton trucks and YOURS is a 1/2 ton and it REQUIRES a 4L60E transmission to be put back in it.
Nope, the 94 would be a half circle bell housing and the 97 would be a full circle bolt on bell housing.
I do not know for sure. but I do know you can get an adaptor plate to bolt it up to a 700r4. Butthey are very expensive.
That bolt pattern is an 8 bolt pattern.
It will bolt up to the engine just fine the bolt pattern on the block is the same. You will have to move the crossmember back and get a driveshaft and a new transfercase also you need the PCM and wiring harness from the 3500 because the computer signals are different. It will not bolt up and run you have to do A LOT of modifications.
THE bolt pattern is 5x110mm only! THE bolt pattern is 5x110mm only! THE bolt pattern is 5x110mm only!
Bolt pattern for what? Nearly everything that has more than one bolt has a bolt pattern. Are you looking for the wheel bolt pattern? Or the torque pattern for say, the intake manifold bolts?
GM's bolt pattern has remained consistant over the years. 5-bolt pattern: 5x4.75" 6-bolt pattern: 6x5.5" 8-bolt pattern: 8x6.5"