910 cranking amps 700 cold cranking amps
910 cranking amps 700 cold cranking amps
Please give the voltage and Ah rating of the battery and voltage rating of bulb.
That is 10 amp wire.
C/20 is the formula most commonly used to describe a battery according to its amp hour rating; for instance a 400Ahr rated battery means that a 20 amp load placed upon the battery delivers at that rate of energy for 20 hours upon reaching the manufacturer's per cell rating, usually about 1.7 volts or 10 volts for a dead, discharged battery. There are different discharge or load ratings such as a 10 hour or 100 hour rating resulting in a different Amp Hour rating for the very same battery. A battery is an electrical potential energy source whose capacity (amount of energy density delivered over time) is determined by the rate/time over which the battery will deliver a set rate of load/discharge. The lesser the load, the longer the rate, the higher the load the shorter the rate.
To answer this question the amp hour rating of the battery is needed along with the voltage of the battery or bulb.
It is one amp current used over one hour. A ten amp hour battery can supply 1/2 an amp for 20 hours, 1 amp for 10 hours, etc.
Connect them in parallel. They must be the same voltage and the same or similar amp-hour rating.
You need to instal the same size and amp rating as you removed.You need to instal the same size and amp rating as you removed.
The 50 amp charging circuit will never be able achieve a full charge for the 70 amp hour battery, thus in effect turning the 70 amp hour battery into a 50 amp hour battery.
the battery amp hour (ah) rating is what is important as long as the new battery has the same or higher ah rating it should be OK
3Amp
1 ton ac amp