Assuming the wire follows Ohm's Law, the resistance of a wire is directly proportional to its length therefore doubling the length will double the resistance of the wire. However when the length of the wire is doubled, its cross-sectional area is halved. ( I'm assuming the volume of the wire remains constant and of course that the wire is a cylinder.) As resistance is inversely proportional to the cross-sectional area, halving the area leads to doubling the resistance. The combined effect of doubling the length and halving the cross-sectional area is that the original resistance of the wire has been quadrupled.
Double the length is double the resistance. Resistance of a wire is the resistivity of the material, times the length, divided by the cross-section area.
As the length of the wire increases, the resistance also increases. This is because a longer wire offers more opposition to the flow of electrical current compared to a shorter wire. Resistance is directly proportional to length, so doubling the length of the wire will double its resistance.
If you double the length of the wire while keeping the resistance constant, the current will halve because resistance is directly proportional to the length of the wire. This is described by Ohm's law (V = I * R), where V is voltage, I is current, and R is resistance.
The resistance of a wire is directly proportional to its length, so doubling the length will also double the resistance. Therefore, doubling the 4 ohm resistance wire will result in a new resistance of 8 ohms.
Decreasing the length or increasing the thickness of the wire would cause its resistance to decrease.
You can increase the resistance in the wire, by doing any of the following:Increase the length of the wire.Reduce the wire's cross-section.Change to a material that has a greater resistivity (specific resistance).You can increase the resistance in the wire, by doing any of the following:Increase the length of the wire.Reduce the wire's cross-section.Change to a material that has a greater resistivity (specific resistance).You can increase the resistance in the wire, by doing any of the following:Increase the length of the wire.Reduce the wire's cross-section.Change to a material that has a greater resistivity (specific resistance).You can increase the resistance in the wire, by doing any of the following:Increase the length of the wire.Reduce the wire's cross-section.Change to a material that has a greater resistivity (specific resistance).
The resistance of a wire is directly proportional to its length, so if the length is reduced by half, the resistance will also be reduced by half.
The resistance of a wire is directly proportional to its length. This means that as the length of the wire increases, the resistance also increases. This relationship is described by the formula R = ρ * (L/A), where R is resistance, ρ is the resistivity of the material, L is the length of the wire, and A is its cross-sectional area.
Assuming the wire follows Ohm's Law, the resistance of a wire is directly proportional to its length therefore doubling the length will double the resistance of the wire. However when the length of the wire is doubled, its cross-sectional area is halved. ( I'm assuming the volume of the wire remains constant and of course that the wire is a cylinder.) As resistance is inversely proportional to the cross-sectional area, halving the area leads to doubling the resistance. The combined effect of doubling the length and halving the cross-sectional area is that the original resistance of the wire has been quadrupled.
The wires in the resistance box are double folded to reduce their resistance value by a factor of 4, as resistance is inversely proportional to the cross-sectional area of the wire. This allows for more precise resistance increments to be achieved by varying the length of wire exposed in the circuit.
Yes, resistance is directly proportional to the length, and inversely proportional to the cross sectional area. R = p*l/A. Where R is the resistance of the piece of conducting material, p is Greek letter rho, representing the resistivity of the material, l (lower case L) is the length, and A is the area.
Resistance in a wire is caused by collisions between electrons and atoms in the wire, which slows down the flow of electrons. Factors that can influence the resistance of a wire include the material it is made of, its length, cross-sectional area, and temperature.