0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is throat of fillet weld?
A fillet weld is a triangular weld with sides of a width, w by w . The throat is the thinnest portion, which is w divided by square root of 2. The throat thickness is used in stress calculations
What is fillet welding?
A fillet weld is the joint of 2 pieces of material, usually at a 90 degree angle. see http://www.unified-eng.com/scitech/weld/fillet.html
Leg or filet weld?
Leg of the weld. Fillet is the part you cut off e.g. a corner...
Butt-weld and grrove weld?
First, Butt-weld is short for a butt groove. Welding in a butt-groove starts at the throat of the butt-groove. The first weld point could be a tack-weld: holding the two materials to be welded together. The throat is measured and filler metal and electrode are determined to create the root pass.
What is the height of a weld above the base metal in a groove weld called?
a crown
Where does the roots opening on a groove weld symbol?
To find the root opening on a groove weld symbol one must measure the depth of filling for plug & slot weld. Rhianna Berriman
Where does the root opening appear on a groove weld symbol?
To find the root opening on a groove weld symbol one must measure the depth of filling for plug & slot weld. Rhianna Berriman
How long does it take a human to weld a 1 foot fillet weld?
It depends on the thickness and type of materials being welded.
What does the term Undercut mean in welding?
Undercutting is a defect that appearsas a groove in the parent metal directly a;ong the edges of the weld it is most common in lap fillet welds, but can also be encountered in fillet and butt joints. This type of defect is most commonly caused by improper welding parameters, particularly the travel speed and arc voltage
What is the filet weld size required for weldolets to main pipe joint?
wildly welding main pipe the are fillet weld or butweld
Difference between weldolet and sockolet in piping?
Weldolet has a Bevelled end to butt weld the pipe whereas in sockolet the pipe/tube goes inside it and there it is fillet welded.
What is definition of the under run in filet weld?
A fillet weld in any single continuous weldmay underrun the nominal fillet weld size specified by2 mm [1/16 in] without correction, provided that theundersize portion of the weld does not exceed 10% of thelength of the weld. On the web-to-flange welds on girders,underrun shall be prohibited at the ends for a lengthequal to twice the width of the flange.
