answersLogoWhite

0


Best Answer

The input voltage, an AC Sine Wave will have a Peak-to-Peak value equal to 2X its Peak value. Once rectified, all the Peaks will be either above or below the Zero reference line. They'll look like a series of identical bumps.

The net value of the unrectified voltage will be Zero. The positive and negative waveforms canceling each other out. The rectified waveform will be all positive or negative and its net value will be non-zero.

Its AVERAGE value will be .636 times its Peak value. Its Root Mean Square (RMS) value will be .707 times its Peak value. Its Peak-to-Peak value will equal 1X the Peak value.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the Relationship between the peak-to-peak DC voltage across RL and the peak input voltage in full wave rectifier?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What has the highest output voltage because of the lower voltage drop between peaks?

A halfe-wave rectifier


How can capacitor smooth or reduce the ripple of the voltage produced by the rectifier?

when rectifier is on, the capacitor is almost transparent (it charges to the voltage provided from the rectifier) when rectifier is off, capacitor holds the peak voltage since it stored a charge during rectifier on time.


What are the Importance of of peak inverse voltage in rectifier service?

What are the Importance of of peak inverse voltage in rectifier


What device is also called a rectifier?

A rectifier is an electronic device that changes an AC voltage to a DC voltage.


Why an op-amp diode rectifier called as a precision rectifier?

In a rectifier made of just diodes, the diodes have a voltage drop, resulting in a lower DC output voltage. By introducing an Op-amp, this voltage drop can be overcome. Since there is no voltage drop caused by the diodes, the rectified signal is not changed by the rectifier, so it is called a precision rectifier.


What is the average voltage of a full-wave rectifier if the peak voltage is 900 volts?

between 900 and 600 depending on load and capacitance


What is tha purpose of a rectifier assembly?

Are you referring to the Rectifier in the Alternator? Simply, a rectifier turns the AC voltage produced my the alternator to run the electrical components in your vehicle and turns it into DC voltage to recharge your battery.The purpose of rectifier assembly is to turn the AC voltage. This is in a car.


Which type of rectifier has the greatest output voltage for the same input voltage and trasformer turns ratio?

Bridge Rectifier


The difference between a transfer and a rectifier?

A transformer is basically used to step up or step down the main power supply. The rectifier is used to convert an alternating current (AC) or voltage to direct current (DC) or voltage.


Where is the voltage rectifier on a 1985 Suzuki Gs300 L?

The voltage rectifier is on the left side of the motorcycle just in front of the rear tire.


What is the basic difference between a full wave bridge rectifier and a full wave center tapped rectifier?

A full-wave bridge rectifier with 4 diodes gives a dc output voltage equal to the average voltage of the whole transformer secondary. A FW rectifier with 2 diodes and a centre-tapped secondary gives an output voltage equal to the average voltage of half the secondary. If you have a 12-0-12 transformer, the bridge gives a 24 v output, while the 2-diode FW rectifier gives 12 v (approximately).


How the capacitor removes the ripples from the rectified voltage?

During the AC cycle, the capacitor charges when the rectifier conducts, and maintains the voltage when the rectifier is not conducting.