0
One of the hottest furnaces is the solar powered furnace in the Basque region. It can reach a temperature of almost 3,500 deg C.
Wiki User
∙ 6y ago
Add your answer:
Earn +20 pts
What is the typical flue gas temperature of a category 3 furnace?
120
If a forced-air furnace heats a house until all the air is the same temperature as the air coming from the furnace then?
no heat would flow
What is the cool temperature range and what is mean by cool temperature?
It means you are a fail for not knowing.
What is the temperature range of 6s thermometer?
It is from -50 to 70
What is the temperature range of gas thermometer in celsius?
-183 to 100
Why blast furnace called as blast furnace?
Its because air is forced into the furnace to increase temperature. Steve.
How do you get the right temperature on the elemental furnace in RuneScape?
ou don't. ONce you finish the quest for the elemental furnace, it's stays that temperature. Contribute me.
How can you test thermostat in your furnace?
Set thermostat to desired temperature; lets say, 70 degrees Fahrenheit, a few seconds will go by then the furnace should activate. Once the furnace heats the room to the set temperature the furnace should shut off.
What is a two phase furnace?
A two phase furnace includes 2 types of heat. Usually it is composed of an electric heat pump and also a nat. gas/ propane heat source when the temperature drops below a set range. The reason they use these is because heat pumps are very efficient when there's not a large temperature change required, but they're efficiency drops dramatically when the outside temperature (or ground temperature) drops below freezing. The only other two-phase furnace would be a two-phase electric (as opposed to a three-phase electrical furnace.) But I don't think you're asking about 2 vs 3 phase electrical furnace systems... Those are quite rare.
Where can someone purchase temperature controllers for the furnace?
One can purchase a temperature controller for the furnace from many different stores. Some examples that sell temperature controllers for furnaces include Fragtastic Reef and Instron.
How do you measure the temperature of a furnace?
You could use a thermocouple.
How would you find the temperature inside a furnace?
A thermometer....
What is the best temperature to set your furnace?
The temperature should be set according to your comfort preferences. The temperature at which most people feel comfortable is in the range of 68°F to 72°F. Setting the furnace temperature higher will result in increased operating cost, as heat is lost through air leaks and radiation, especially when the temperatures outside are low and when it is windy. It is possible to run the furnace at much lower temperatures to save money, in the range of 58°F to 68°F, if one dresses warmly and doesn't mind wearing bulky clothing indoors during the winter. Remember that thermostats have a built-in temperature hysteresis, or "swing". Whatever temperature you choose, the furnace will operate a degree or two above and below the setpoint, so if you set the thermostat to 70°F, you'll observe the room temperature cycling between, say, 68°F and 72°F. This is normal. The hysteresis value in many electronic thermostats can be adjusted by the user according to preference. A larger hysteresis value results in the furnace cycling less frequently, but running longer once it comes on.
What electrical devices has to be kept at a constant temperature?
furnace, fridge
How do you find the temperature inside a furnace?
s h i t
What could be the cause of water leaking from a new furnace?
Water leaking from a furnace most likely occurs from the heat of the furnace which transforms into a liquid. The best way to avoid the leak is to put your furnace at a lower temperature.
How do you determine net stack temperature?
the net stack temperature is determined by substructing the ambient temperature ( around the furnace) from the stacke temperature (vent temperature)
