check for a code . usually means you need a new thermostat
I have a 04 Colorado its easy..... put the key in run and push the GAS IN 3 TIMES and its fixed!!
How do I take off the handle to put a new one on a chevy colorado 2005
usually just unhook your batt for 30min it should clear it out
usually just unhook your batt for 30min it should clear it out
Take it to a shop or take the batter out and let it reset itself then put the batter back in
unscrew the light from the car, it should pop out. Twist the light bulb out and then pop the light off from the base. Reverse to reassemble.
I have an 06 Colorado and there was a recall on them for that. Might be something to check into.
Depress the accelerator 3 to 4 times with the ignition in the on position (with the truck off). You may or may not hear a audible tone.
Begin by removing the tire and wheel from your 2004 Chevy Colorado. Remove the brake assembly. Loosen the brake rotor with a hammer or mallet. Slide the brake rotor off.
Lift up on the E-brake until the first click. This works for any vehicle (Chevy at least) with daytime running lights.
Pull the positive battery cable off and wait about 10 minutes. This resets all codes in the PCM. But, if you haven't fixed the reason the light came on, the light will only come back on again.
set info to oil life turn key off then turn key to on postion with engine off pump gas pedal 3 times