if check voltage is 2000v then acceptable range is 400
The voltage drop should not exceed 3% on a feeder or branch circuit.
All electrical equipment, regardless of the voltage, should have a voltage supply that is no more than plus or minus 5 per cent of the equipments stated voltage requirement.
The voltage range should be marked on the case but without that information a 5% increase can be assumed, so 504 v.
Regulation has to do with keeping the voltage at a desired value. This is often put in a per unit value, which you can think of as a percent of nominal. So if the desired voltage is 34.5kV, and the actual voltage is 33.8kV, the voltage is .98 per unit. There are regional and national rules on how low or high voltage can be. If the voltage strayes from this, it must be regulated back to an acceptable value.
The acceptable range of ac voltage at an outlet is from 115 to 120 volts. The utility company has a mandate to keep the voltage within a 10% fluctuation range. The catch is 10% from what set point voltage.
if check voltage is 2000v then acceptable range is 400
CODE 23** Indicates that the air temp sensor input is below the minimum acceptable voltage or sensor input is above the acceptable voltage.
When doing voltage drop calculations the voltage to the connected devices should not drop below 3 % of the supplied voltage. <<>> "Most" appliances? that a tough one there is no standard. A few percent is no trouble, different appliances have different tolerances: no generalizations are possible.
The voltage drop should not exceed 3% on a feeder or branch circuit.
It tries to attain an acceptable level of veracity.
Fully charged should be around 12.8
If you are asked a question and you do not know the answer, yes, it is an acceptable answer. If you do not know the answer to a question asked on this site, it is not acceptable to answer with "I don't know."
If you are asked a question and you do not know the answer, yes, it is an acceptable answer. If you do not know the answer to a question asked on this site, it is not acceptable to answer with "I don't know."
110 volts
All electrical equipment, regardless of the voltage, should have a voltage supply that is no more than plus or minus 5 per cent of the equipments stated voltage requirement.
The voltage range should be marked on the case but without that information a 5% increase can be assumed, so 504 v.