5.1v is the Voltage, You need to also look at what the Amperage rating is on the charger. 500ma, 1000ma, etc. How many Milliamps?
Wattage = voltage x amperage. Every appliance in North America is built to work at 120 V, so you have the voltage. The amperage rating is probably written in the microwaves manual if the wattage is not. Remember the amperage you put on a circuit can't be more that 80% of what the wiring is rated for in the branch circuit.
200 amps
The ampere rating of wire would depend on the diameter, length and usage of wire for specific purpose. Without additional input to the question. it will be hard to give an accurate answer.
define motor service factor? define motor service factor?
It is ok to use a fuse with a higher amperage rating and not ok to use a fuse with a smaller amperage rating why?
KCM was born in 1982.
Usually the current rating for a circuit is higher than the current usually taken. This leaves a little margin for safety.
No, a fuse of a higher amperage rating will not usually have a higher melting point link. The higher amperage fuse will use a wider link or a link of larger diameter.
600amps
If you know the voltage being supplied, divide that into 500kVA. For example for 120 Volts the amperage would be 500,000/120 = 4166.66 Amps.
5.1v is the Voltage, You need to also look at what the Amperage rating is on the charger. 500ma, 1000ma, etc. How many Milliamps?
Wattage = voltage x amperage. Every appliance in North America is built to work at 120 V, so you have the voltage. The amperage rating is probably written in the microwaves manual if the wattage is not. Remember the amperage you put on a circuit can't be more that 80% of what the wiring is rated for in the branch circuit.
200 amps
A zener diode with a rating of 500 mW will pass 50 mA at 10 V. (Power = voltage times current)Note: The question appears mis stated, in that it states a rating of 500 MW, not 500 mW. To my knowledge, there is no zener with a rating of 500 MW.
With out knowing the amperage rating of the panel, an answer can not be given.
v-6 standard is 100 amps