Try mixing 2 parts Bicarbonate of Soda mixed with 1 part vinegar (or lemon juice which smells nicer) into a paste and scrub in with an old nail or toothbrush. Leave for about 5-10 minutes then rinse off.
No nasty chemicals required. By the way - when you add the vinegar/lemon juice it will get fizzy. :)
Grout.
First you lay out all the tiles with spacers adhering them to the floor, then you grout between by scraping across surface of tiles. Then just wipe clean. The grout is like a concrete mix & will harden.
To lay pool tiles, you will need mortar to affix the tiles to the cement pool, you will also need grout for between the tiles and a sponge to clean the tiles.
there is a special cleaner at lowes in the cleaner isle.
I have a lot of mould around my bathroom tiles and don't seem to be able to get it out from the grout in between. What grout cleaner will work best for this?
Grout residue can be removed with commercial products available at home centers and hardware stores. The grout removers generally contain an acid which reacts with the lime in the grout cement, dissolving it.
"Grout is the stuff you apply between tiles to seal them in place. Grout tiles once the adhesive has dried fully (24 to 36 hours later). The best grout is waterproof and mould-resistant; some come ready-mixed. Use a grout float - a rubber-faced tool with foam backing - for large areas. Spread the grout across the tiles at right angles to the joins. Use a damp sponge to remove excess. Once the grout is dry, polish the surface with a dry cotton rag." I was taught by a contractor to apply and clean the grout diagonally.
Reliable information can be found from the Lowes website or visiting your local store as the staff are expert on tiles and how to keep them clean from tile grout.
It seals the cracks in between tiles to make a nice white grout.
You would need 216 tiles if you left no space between them for grout.
One of the most important components of any tiling project is grout, a soft adhesive material that is used to fill in the seal joint spaces in tiles. When applying grout in between the tiles, the right type of trowel is needed to create the patterns that will match the back and side surfaces of the tiles. After the grout dries up, it is important to immediately sand the tiles and apply sealants. The sanding process can be done with standard sanding paper. Additionally, a soft moist sponge should be used to wash any excess grout from the top surface of the tiles. The sealant will help prevent dirt from accumulating in between the tiles.
NO. Because they are vinyl, they will expand and contract at a different rate than grout, which is essentially concrete. You are supposed to lay vinyl tiles tightly together, with no gaps in between.