You first need to loosen the Idler pully nut that the power steering and altenater belt rides on. Then right behind the idler pully you need to loosen the bolt counter clockwise until tension is released enough to get belt off. Then loosen retainer bolt just below tensioner on a/c belt. You then need to move down tensioner to install/remove a/c belt(best results with braker bar). Repeat steps backwards and tighten all bolts to install. Travis
1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.
1999 dodge intrepid rear windo don't know working i change 2 time same place you can Email .e email@example.com
where is fuel line located on 1999 dodge intrepid
battery on a 1999 dodge intrepidYou may have to remove the front driver side wheel to gain access to the battery compartment. At least that's where it is on the 1998 Dodge Startus. hope this helps.
How do I change the oil pan gasket on a 1999 Dodge Intrepid with 3.5 engine, what is the proper torque for the bolts.
No. A 1999 Dodge does not have a reset switch.
You take the old one out and put the new one in.
Yes, 2nd Generation Intrepid was made from 1999 through 2004 IDENTICAL Cars Actually, it was 1998 through 2004.
A Dodge mechanic.
The factory amp on a 1999 dodge intrepid is located on the right kick panel behind the dash.
If a 1999 Dodge Intrepid timing chain goes out a valve in the head can easily be damaged.
I need a cooling system diagram for a 1999 dodge intrepid 2.7
On top of the starter
on the bottom of the engine
The Intrepid did not use any engines that had distributors, so no cap.
No. The 1997 computer system is completely different than the 1999 system.
There is no fuel pump inertia switch on a 1999 Dodge Intrepid.
In front of the radiator
1lb 6oz 134A