Want this question answered?
Either cut it out on the pipe with copper cutters or sweat it out with a plumbing torch.
A pipe cutter is the best tool to cut PVC pipe.
Copper tubing is best cut with a straight saw, ideally diamond tipped for the cleanest cut.
Get rid of the entire copper pipe and fit 3/4 PEX from the street main into the house. Cheap and reliable.
One way is to cut olive at an 45 degree angle and cut with small hacksaw. The problem with this is that it may flare or damage the pipe, leading to replacement of the whole pipe. An easier way is to use a tool such as the olivepulloff tool (it costs about £20 and you can get one easily from Jee Dee Tools website). These do a good job, are quick and easy to use, and quite neat in removing olives off copper pipes. Further, even in space constraints, for example when removing olives off shower pipe's, a good olive puller will remove the olive off the copper pipe without leaving any damage to the pipe.
Use a pipe cutter to cut the connector about two inches away on all sides. Use a shark pipe connector to replace the copper T-connection with aCPVC connection.
solder it or cut it out and install new pipe. making sure when you cut you make cut where the pipe is still round and use fernco apts. to put back together. if it is in a tough place to do, best to get a plumber
Cut it in the middle and replace it with 2 pieces with a union connecting them together.New answerIf the galvanized pipe is used for Vent or waste and your local codes permit YOU can cut the pipe remove it and install a shorter piece connected with a NO HUB Coupling. If the pipe is used for potable water cut out the galvanized pipe use a dielectric nipple then use a female x copper adapter to prevent electrolytic action
An inside pipe wrench also called a pipe extractor. It drives into the broken off pipe and is then turned with a crescent wrench.Normally a extractor or inside pipe wrench does not work removing a pipe . What works best is the use of a hack saw blade and a chisel to cave in the threads after the threads are cut.. BECAREFUL not to cut into the fitting threads
saw
Burrs.
Cut out bad section- cleax flux couplings and piping and resolder using lead free AWWA /ASSE approved alloy